Filter
Top Products
General Commands
After entering into the application program for CLI commands, press the “?” key in the command line to
get the list of the commands.
Command Description
?/help To get a list of commands for the system
showmac View MAC address
showip View the IP address
showmask View the subnet mask
showgw View the gateway
showsnmpget View the GET/GETNEXT community of SNMP
snowsnmpset View the SET community of SNMP
setsnmpget Configure the GET/GETNEXT community of SNMP
setsnmpset Configure the SET community of SNMP
setip Configure the IP address
setmask Configure the subnet mask information
setgw Configure the gateway information
setmac Configure the Ethernet MAC address
showsysinfo View the system information
sete1loop Enable/Disable the loopback of the E1 port
showe1loop View if the E1 port is looped back
e1alarm View the alarms of E1 tributary
setcvmode Configure the receive mode of the laser port
showlaser View the current status of the laser port
reset Perform a hot restart
setdefault Configure the settings as default
enableport Enable/Disable the Ethernet port
setport Configure the Ethernet port
showport View the Ethernet port configuration
ethperform Clear the perform counter data
ethstatus View Ethernet status
clearperform Clear the perform counter data
adduser Add a manager to TELNET
deluser Delete a user from TELNET
showuser View information of the TELNET manager
showrpd View the status of remote system power detroy alarm
sete1mask Configure the alarm mask of the unused E1 interface
showe1mask View the configuration of unused E1’s alarm mask
clearcv Clear the record of E1’s CV alarm
settonemask Configure the status of the alarm tone mask
showtonemask
showcontact
View the status of alarm tone mask
View the contact details
General Commands 35
Model 1195 Getting Started Guide 5 • CLI configuration