Filter
Top Products
11 of 33
ISSUED: 09-20-06 SHEET #: 202-9167-3 01-26-07
Mounting and Removing Flat Panel Screen
Adjust tension knobs shown in detail 2 to desired
tension, balancing your screen size and weight. The
tension knob, without changing the bracket tension,
can be pulled out, away from the bracket and turned
independently of the knob post for readjustment as
shown in Detail 3.
Push or pull from top or bottom of screen to adjust
tilt as shown in figure 6.1. The tilt can be adjusted to
a maximum of 15° forward or 5° backward.
NOTE: To lock the screen into the desired tilt
position, use locator hole to find tilt position hole.
Tighten IncreLok™ tilt locking screws on both tilt
brackets as shown in figure 6.1 and detail 2.
Adjusting the Tilt Angle of the Flat
Panel Screen
• Be careful not to pinch fingers when pushing screen
from the bottom.
CAUTION
BB and CC
AA
DETAIL 1
AA
DETAIL 2
fig 6.1
SAFETY
SCREW
IncreLok™
TILT LOCKING
SCREW
LOCATOR
HOLE
TENSION
KNOB
fig 5.1
fig 5.2
© 2006 Peerless Industries, Inc. All rights reserved.
Onemount is a trademark and Peerless is a registered trademark of Peerless Industries, Inc.
All other brand and product names are trademarks or registered trademarks of their respective owners.
TILT POSITION
HOLES
CS = center of screen
DETAIL 3
TENSION
KNOB
NOTE: For security, replace safety screw in each tilt
bracket with M5 x 30 security screw (HH) using
wrench (II).
Adjust brackets to full back tilt position and tighten.
Hook tilt brackets (BB and CC) onto wall plate (AA).
Then slowly swing screen in as shown. Turn safety
screws, using wrench (II), clockwise till fully
tightened down and screw tip securely contacts bottom
of the wall plates as shown in detail 1. of figure 5.1.
Center of screen can be adjusted horizontally no more
than 4" from center of the wall plate configuration, if
desired as shown in figure 5.2.
NOTE: To lock the screen down, tighten safety screws
to wall plate using a wrench (II) as shown in detail 1.
To remove screen from mount, loosen safety screws,
swing screen away from mount, and lift screen off of
mount.
CS
4"
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
CAUTION
• Always use an assistant or mechanical lifting equip-
ment to safely lift and position the plasma television.
WARNING