Filter
Top Products
7 of 33
ISSUED: 09-20-06 SHEET #: 202-9167-3 01-26-07
With tape measure, measure the outside to outside of the brackets on the back of your screen. If width of the tilt
brackets on back of the screen is over 18-1/2" shown in figure 3.1, using a 7/16" wrench, attach wing bracket (GG)
to center bracket using two 1/4" serrated flanged locknuts (FF) as shown in figure 3.2. If width of the brackets on
back of the screen is over 30-3/8", using a 7/16" wrench, attach second wing bracket (GG) to center bracket using
two 1/4" serrated flanged locknut (FF) as shown in figure 3.3.
CAUTION: If mounting to two studs on 16" centers, and using the three plate configuration, A STUD
MUST BE SKIPPED in the middle so distance between studs is 32".
AA
18.5"
fig. 3.1
fig. 3.3
FF
AA
GG
fig. 3.2
AA
GG
FF