Filter
Top Products
2 of 33
ISSUED: 09-20-06 SHEET #: 202-9167-3 01-26-07
Note: Read entire instruction sheet before you start installation and assembly.
Tools Needed for Assembly
• stud finder ("edge to edge" stud finder is recommended)
• phillips screwdriver
• drill
• 1/4" bit for concrete and cinder block wall
• 5/32" bit for wood stud wall
• level
• 7/16" socket or crescent wrench
• tape measure
Table of Contents
Parts List .............................................................................................................................................................................. 3
Adjusting Tilt Brackets .......................................................................................................................................................... 4
Attaching Tilt Brackets to Screen using Baffled Fastener Pack ............................................................................................ 5
Installation to Double Wood Stud Wall ..................................................................................................................................8
Installation to Triple Wood Stud Wall ....................................................................................................................................9
Installation to Solid Concrete or Cinder Block ..................................................................................................................... 10
Mounting and Removal of Flat Panel Screen....................................................................................................................... 11
For customer care call (800) 729-0307 or (708) 865-8870.
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings
contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please
call Peerless customer care at 1-800-729-0307.
• This product should only be installed by someone of good mechanical aptitude, has experience with basic building
construction, and fully understands these instructions.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard-
ware and components.
• Never exceed the Maximum UL Load Capacity. See page one.
• If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of an
"edge to edge" stud finder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power.
WARNING
Accessories:
• ACC927, ACC927-S