Filter
Top Products
8 C2647M-B (10/09)
d. Using a Phillips screwdriver, remove and set aside the four screws that secure the drive to the sides of the cage.
Figure 7. Removing the Screws from the Hard Disk Drive in the Cage
e. Slide the drive out of the cage. Avoid scratching the bottom of the drive against the metal sides or the bottom of
the cage.
Figure 8. Removing the Hard Disk Drive from the Cage
f. Repeat steps d and e for the second drive, if needed. In a two-drive system, you do not need to remove both
drives when replacing only a single drive.
3. To install a replacement or upgrade hard disk drive:
a. Slide the drive into the cage. Avoid scratching the bottom of the drive against the metal sides or the bottom of
the cage.
b. Using a Phillips screwdriver, attach two of the supplied screws on each side of the cage to secure the drive in
place. Do not overtighten the screws.
c. Repeat steps a and b for the second drive, if needed.
WARNING: Use a Pelco-certified hard disk drive only (250 GB, 500 GB, 1 TB, 1.5 TB, or 2 TB). Using any other hard
disk drive with the DVR5100 voids the manufacturer's warranty for the unit.