Filter
Top Products
25
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio or television technician for
help.
Modifications -
The FCC requires the user to be notified that any changes or
modifications made to this device that are not expressly approved by
Philips Consumer Electronics may void the user’s authority to operate the
equipment.
Cables -
Connections to this device must be made with shielded cables with
metallic RFI/EMI connector hoods to maintain compliance with FCC Rules
and Regulations.
Canadian notice -
This Class B digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
Avis Canadien -
Cet appareil numérique de la classe B respecte toutes les exigences du
Règlement sur le matériel brouilleur du Canada.
Regulatory Notices - Federal Communications Commission Notice
Audio and video equipment buttons
rc 4345 audio-video -tv
g
.e
p
s
Some of the audio and video equipment from our range of products can be operated with the
remote control of your TV.
Press one of the buttons after you pressed the SELECT button repeatedly according to the
equipment you want to operate with this remote control. See Use of the remote control, p.
5.
When no action is taken within 60 seconds, the remote control goes back to TV mode.
POWER to switch to standby
º for pause,
® for record,
Ò for rewind (VCR, CD);
search down (DVD, AMP)
‡ for stop,
π for play,
† for fast forward (VCR, CD);
search up (DVD/AMP)
INFO display information
MENU to switch the menu on or off
- CH + for chapter, channel, track selection
0 to 9 digit entry,
- tape index (VCR),
select a DVD chapter,
select a frequency (AMP)
cursor up/down
to select the next or the previous
disc (CD)
cursor left/right
to select the previous or following
track (CD)
Notes:
- If no action is being undertaken within 60 seconds, the remote control returns to TV mode.
- After an action in the selected system mode, the remote control will remain in this mode for
60 seconds and will then return to TV mode or press the SELECT button to return to TV mode
immediately.
& Press the AV+ button repeatedly or select Source in the Settings menu
(see p. 13) to select AV1, AV2, AV3, HDMI, Side or TV, according to
where you connected your devices.
é Press the cursor up/down.
“ Press OK.
rc 4342 av.eps
.@
TUVPQRS WXYZ
JKLGHI MNO
ABC DEF
+
-
+
-
DVD/R CBL TV VCR AUX
PIPMENU
1 2 3
4 5 6
7 8 9
0
¨
¨
¨
¨
TV
GUIDE
SELECT
DEMO CLOCK
MY CONTENT
VOL
CH/
PAGE
MUTE
AV+
-
ñ
à
¹
¼
POWER
3
- FAVORITES -
ACTIVE
CONTROL
REC
VIEW
CC
INFO
OK
=
_-
To select connected devices
EnglishFrançaiseEspañol