Filter
Top Products
16
USING THE MENUS :PICTURE
Converge Red
Converge Red
PICTURE
MANUAL CONVERGE
G
CONVERGE RED
•
‰
•
CONVERGE BLUE
•
MULTIPOINT RED
•
MULTIPOINT BLUE
•
SAVE MULTIPOINT
•
•
Using Manual Converge : Converge Red/Blue
Using the Auto IntelliSense
®
feature, you can automatically adjust con-
vergence in 20 seconds or less (see the previous page). Also, if you
desire, you can use the Manual Converge controls to make additional
convergence adjustments to suit your personal preferences or to further
fine-tune the picture.
Note : Allow the TV to warm up for 20 minutes before adjusting conver-
gence.
1
Select MANUAL CONVERGE in the PICTURE menu.
2
Press the cursor down and select either CONVERGE RED
or CONVERGE BLUE.
Note : If various images in the picture have red outlines,
select CONVERGE RED. If various images in the picture
have blue outlines, select CONVERGE BLUE.
3
Use the cursor right, left, up, or down to adjust the cross
hair until the color outline is gone. The adjustment is auto-
matically saved in the TV’s memory when you exit the
adjust mode.
4
Press the MENU key to return or the m key to switch the
menu off.
Check the TV picture. If any color outlines remain around
the images, use the MULTIPOINT RED (for red outlines)
or MULTIPOINT BLUE (for blue outlines) control. See
the next section for instructions for using those controls.