Filter
Top Products
42
User Manual BDS4241R
9.2 TROUBLESHOOTING
No picture is displayed
Interference displayed on
the PDP or audible noise
is heard
Color is abnormal
Picture is distorted with
abnormal patterns
Display image doesn't fill
up the full size of the
screen
Can hear sound, but no
picture
Can see picture but no
sound is heard
Some picture elements do
not light up
After-Images can still be
seen on the PDP after the
PDP is powered off.
(Examples of still
pictures include logos,
video games, computer
images, and images
displayed in 4:3 normal
mode)
RemedyPossible CauseSymptom
1.The power cord is disconnected.
2.The main power switch on the back of the PDP is
not switched on.
3.The selected input has no connection.
4.The PDP is in standby mode in RGB mode.
Caused by surrounding electrical appliances,
cars/motor cycles or fluorescent lights.
The signal cable is not connected properly.
1.The signal cable is not connected properly.
2.The input signal is beyond the capabilities of the
PDP.
1. If under RGB mode,the H-Size and V-Size is
incorrectly set.
2. If under AV1,AV2,or Component with 480i input,
the 4:3 WIDE mode is switched on.
Improperly connected source signal cable.
1. Improperly connected source signal cable.
2.Volume is turned all the way down.
3. MUTE is turned on.
Some pixels of the plasma display may not turn on
A still picture is displayed for an over extended
period of time.
1. Plug in the power cord.
2. Make sure the power switch is switched on.
3. Connect a signal connection to the PDP.
Move the PDP to another location to see is the inter-
ference is reduced.
Make sure that the signal cable is attached firmly to
the back of the PDP.
1. Make sure that the signal cable is attached firmly.
2. Check the video signal source to see if it is beyond
the range of the PDP. Please verify its specifications
with this PDP's specification section.
1. Use H-Size and V-Size to adjust the size of the
video.
2. Use the I.SIZE button to scroll through various full
screen modes.
Make sure that both video inputs and sound inputs
are correctly connected.
1. Make sure that both video inputs and sound inputs
are correctly connected.
2. Use the VOL+/
-
button to hear sound.
3. Switch MUTE off by using the MUTE button.
This PDP is manufactured using an extremely high
level of precision technology:
however, sometimes some pixels of the PDP may not
display.
This is not a malfunction. Please see the enclosed
warranty card for more information.
Do not allow a still image to be displayed for an
extended period of time as this can cause a perma-
nent after-image to remain on the PDP.
Downloaded From TV-Manual.com Manuals