Filter
Top Products
12
INSERTING YOUR
ACCESS CARD
The access card provided with your system includes
information about your purchase
authorization and other data.To watch channels, your
viewing access card needs to be inserted in the access
card slot on the rear of your Satellite Receiver.
When the card is removed, the system will not display
any programming guides or video signal.The message,
"Please insert your Access Card" will show on the TV
screen.
The access card only needs to be inserted during sys-
tem setup and generally does not need to be
removed. Each access card has a unique number. Be
sure to record this number in the space
provided on the back cover of this manual.
Hold the card with the arrow facing upwards
and pointing toward the slot in the Satellite
Receiver rear panel.
Gently push the card into the slot until it meets
the stop. Do not use undue force when inserting.
The end will be visible outside of the slot.
Keep your access card permanently inserted in
your Satellite Receiver.
Connect one end of the AC power cord to the
Satellite Receiver’s AC IN jack. Connect the
plug end to an AC outlet.This will turn unit on.
When replacing the access card, the system will
prompt you with instructions. Gently remove the card
from its slot. If you have to reinsert the card, you
should have the ARROW facing forward into the box
and the GOLD CHIP facing down. Push the card into
the slot as far as it will go, the end will be visible out-
side of the slot.
The old card passes information to the new card, and
then the old card no longer functions.
R
EPLACING THE ACCESS CARD
• YOUR ACCESS CARD IS FRAGILE.
• ALWAYS INSERT CORRECTLY AND
CAREFULLY.
• DO NOT BEND.
• DO NOT REMOVE AND RE-INSERT
UNNECESSARILY.
• NEVER SUBMERGE IN LIQUID OR
APPLY CLEANING FLUIDS.
Caution
s
Next, go to Switching your Satellite Receiver On and Off on page 13.
S
MART
HELP
Once the Satellite Receiver is powered on,
the Installation Wizard will appear on your TV
screen.You should then proceed to the Installation
Wizard details on page 19.
Note:The Installation Wizard will remain on the
screen only for a few minutes and needs to be
accessed as quickly as possible.This screen will
ONLY appear the very first time your Satellite
Receiver is in use.
VCR controller output
(DSX3575 only)
Secondar
y Audio/Video Outputs
(DSX5353 and DSX5375 only)