Filter
Top Products
The region code for this set is 2.
Since it is usual for DVD movies to be released
at different times in different regions of the
world,all players have region codes and discs can
have an optional region code.If you load a disc
of a different region code to your player,you will
see the region code notice on the screen.The
disc will not playback,and should be unloaded.
Manufactured under license from Dolby Laboratories.“Dolby”
and the double-D symbol are trademarks of Dolby
Laboratories.
This product incorporates copyright protectiontechnology that
is protected by method claims of certain U.S.patents and other
intellectual property rights owned by Macrovision Corporation
and other rights owners.Use of this copyright protection tech-
nology must be authorised by Macrovision Corporation,and is
intended for home and other limited viewing uses only unless
otherwise authorised by Macrovision Corporation.Reverse
engineering or disassembly is prohibited.
2
English
General Information
wThank you for purchasing this Philips DVD/ VCR.This
Owner’s Manual explains the basic operation of this DVD/VCR.
Environmental Information
All unnecessary packaging has been omitted.
Packaging has been made easy to separate into three materials:
cardboard (box),polystyrene foam (buffer) and polyethylene
(bags,protective foam sheet).
Your DVD/VCR consists of materials which can be recycled
and reused if disassembled by a specialised company. Please
observe the local regulations regarding the disposal of packag-
ing materials,exhausted batteries and old equipment.
Supplied Accessories
• Remote control •
Batteries (two AA size) for remote control
• SCART cable
(not available for all versions)
• Audio Cable
• RF Coaxial cable • Owner’s Manual
Safety Information
• To reduce the risk of fire or electric shock,do not expose
this device to rain or moisture.
• Before operating the DVD/VCR,check that the operating
voltage indicated on the typeplate (or the voltage indication
beside the voltage selector) is identical with the voltage of
your local power supply.If not, please consult your dealer.
• Place the DVD/VCR on a flat,hard and stable surface.
• There must be sufficient room in front of the player for the
disc tray to be opened.
• In cabinet,allow about 2.5cm (1 inch) of free space all around
the player for adequate ventilation.
• Do not expose your player to extreme of temperature or
humidity.
• If the DVD/VCR is brought directly from a cold to a warm
location,or is placed in a very damp room,moisture may
condense on the lens of the disc unit inside the DVD/VCR
player.Should this occur,the DVD/VCR would not operate
normally.Leave the player on for about one hour with no disc
in the DVD/VCR until normal playback is possible.
• The mechanical parts of the set contain self-lubricating bear-
ings and must not be oiled or lubricated.
• Never spill liquid of any kind on this unit.If liquid is spilled
into the unit,consult qualified service engineer.
• When the DVD/VCR is switched to Standby mode,it
is still consuming some power. To disconnect the sys-
tem from the power supply completely,remove the
AC power plug from the wall socket.
Symbols Used in this Manual
The below symbols appear in some headings and notes with
the following meanings:
Introduction
Laser safety
This unit employs a laser. Due to possible eye injury,only a
qualified service person should remove the cover or attempt
to service this device.
USE OF CONTROLS OR
ADJUSTMENTS OR PERFORMANCE OF PROCE-
DURES OTHER THAN THOSE SPECIFIED HEREIN
MAY RESULT IN HAZARDOUS RADIATION EXPO-
SURE.
2
The DVD/VCR is in conformity with the
EMC directive and low-voltage
directive.
For Customer Use:
Read carefully the information located at the bottom of
your DVD/VCR and enter below the Serial No.Retain this
information for future reference.
Model No.DVD/VCR
Serial No.________________________________________
LASER
Type Semiconductor laser GaAlAs
Wave length 655 nm (DVD)
790 nm (VCD/CD)
Output Power 0.8 mW (DVD)
0.5 mW (VCD/CD)
(WARNING LOCA-
TION:ON THE
BACKPLATE OF
SET)
CLASS 1 LASER PRODUCT
KLASSE 1 LASER PRODUKT
KLASS 1 LASER APPARAT
CLASSE 1 PRODUIT LASER
Helpful Hints!
• Some DVD video discs require specific functions or allow
only limited functions during playback.
•
“ ”may appears on the TV screen which means that
the function is not available on that specific DVD video
disc.
– Description refers to playback of DVD-video discs
– Description refers to playback of Audio CDs
– Description refers to playback of MP3 files
– Description refers to playback of video CDs.
CD
MP3
VCD
DVD-V
About the PBC Function of VIDEO CD
This unit conforms to ver.1.1 and ver.2.0 of VIDEO CD standard,
with PBC function.
Ver.1.1 (without PBC function):You can enjoy playback picture as
well as music CD.
Ver.2.0 (with PBC function):When using a VIDEO CD with PBC
function,“PBC” appears on the display.
What is PBC? “PBC” stands for the
PlayBack Control.
You can play interactive software using a menu screens.Refer to
instructions of VIDEO CD.