Filter
Top Products
EN - 52
English
52
Display (cont’d)
Progressive Scan
You may adjust the Progressive Scan compatibility.
● If you selected STILL MODE, press ▲ or ▼ to select a
setting, then press OK. This determines the quality of an image in
still mode. If you select FIELD, still images will be stabilized but coarse
due to the small amount of data. If you select FRAME, the images will
be highly defined due to the simultaneous output of two fields.
The default setting is AUTO.
6
Press SETUP to remove the menu.
1
Follow the steps 1-4 in the Display setup on page 51.
2
Press ▲ or ▼ to select PROG. SCAN, then press OK
repeatedly to turn PROG. SCAN ON or OFF. Choose ON if your
TV has Progressive Scan and if the TV is connected to the player’s
COMPONENT VIDEO OUT jacks. Choose OFF otherwise.
The default setting is OFF.
3
Press SETUP to remove the menu.
● If PROG. SCAN is ON, this message appears :
Press ▲ or ▼ to make a selection, then press OK.
If you select NO, the menu disappears and
PROG. SCAN is OFF. If you select YES, this appears :
Confirm your setting, then press OK. The menu will disappear and
the Progressive Scan function will be activated. If you do not press any
buttons for 15 seconds, Progressive Scan will switch to OFF.
DVDVCR SETUP
INPUT
MENU
DISPLAY SUBTITLE ZOOM AUDIO
BACKPAUSESTOP
PLAY
OK
FFWREW
CLEAR TITLE
DISC
TRACKING
OPEN/CLOSE
12
6
5
4
7
8
9
0
+10
3
6
DISPLAY
STILL MODE
AUTO
FIELD
FRAME
STILL MODE
Helpful Hint
• You can set PROG. SCAN to OFF
either in the DISPLAY Menu or by
pressing and holding PLAY B (DVD)
on the front of the player for more
than 5 seconds.
• You can adjust Progressive Scan
Setting in the QUICK SETUP Menu
that appears when you first press
SETUP. With QUICK SETUP selected,
press OK. Press ▼ to select PROG.
SCAN. Press OK to choose OFF or
ON. Press SETUP to remove the
menu.
DVDVCR SETUP
INPUT
MENU
DISPLAY SUBTITLE ZOOM AUDIO
BACKPAUSESTOP
PLAY
OK
FFWREW
CLEAR TITLE
DISC
TRACKING
OPEN/CLOSE
12
6
5
4
7
89
0
+10
3
3
2-3
NO
YES
NOTE
SET
SELECT
Before proceeding...
Make sure your TV has progressive scan.
Connect with component video cable.
If there is no picture or picture is
distorted after selecting “YES” ,
Wait about 15 seconds for auto recovery.
Activate Progressive?
Confirm again to use progressive scan.
If Picture is good, Select “YES” .
NO
YES
SET
SELECT
E8E2CCD_E8E2CCH_EN_v1.book Page 52 Friday, March 9, 2012 6:37 PM