Filter
Top Products
– 30 –
EN / 2A01
THE SHOWVIEW
®
SYSTEM
Follow these steps to set a timer recording with the
ShowView number in your TV guide. Before you
begin:
• Set up the TV programs at the HDR1000. Details
are on pages 21-22.
• Set the clock. Details are on pages 16-17.
• Before you begin, press HDD button so that the
blue HDD light appears on the front panel of the
HDR1000.
Display “Timer” screen.
• Press TIMER button.
Select
“ShowView sys-
tem”.
• Press K or L button.
Then, press OK button.
Set the
ShowView number.
• Press Number buttons to
input the ShowView num-
ber of the TV program you
want to record.
Then, press OK button.
• Press CLEAR button to cancel ShowView number.
• Press { or B button to move the cursor.
Confirm the timer program.
• If you correct the pro-
gram, press B button to
move the cursor to pro-
gram setting position.
Then, press K or L but-
ton to select your desired
program.
Timer
Small Screen
ShowView system
Timer Programming
Timer Review
ShowView No.
-
Small Screen
Numbers
:
0-9
Move :
{
B
Clear :
CLEAR
Choose :
OK
Exit :
RETURN
- - - - - - - -
Timer Programming
Small Screen
Select :
KL
{
B
Choose :
OK
Exit :
RETURN
Start Time
19:30
End Time
20:30
Date Mon./06/May
Program P02/DSF
Frequency
One Time
Episode 1
Rec. Mode
SQ Store
VPS/PDC
Off
Name:
• To stop a timer recording that has started, press
STOP button. The message will appear to con-
firm. If it is OK, press STOP button again.
• “Given Number not correct.” may appear on the
TV screen after step [3] if you enter an incorrect
ShowView number (for example, one that is too
short). In this case, press RETURN button. Then,
enter the correct ShowView number.
• After step [2], a warning message appears when
there are more than 50 titles stored. In this case,
press NAVI button, then delete unwanted titles in
Navigation menu. Or, press RETURN button to
remove the message.
• After step [2], a warning message appears when
more than 20 timer programs have been setup. In
this case, press TIMER button to remove the
message.
Helpful Hints
TIMER RECORDING USING THE SHOWVIEW SYSTEM
Timer
Small Screen
ShowView system
Timer Programming
Timer Review
Continue with step [8] at “AUTOMATIC
TIMER RECORDING” on page 27.
You can correct the data for Frequency, Episode,
Rec. Mode, VPS/PDC if you need.
E4310.QX3 02.8.22 11:19 AM Page 30