Filter
Top Products
English
33
Clock/Timer
Clock setting
See "Preparations-Step 2: Setting the clock".
Timer setting
● The system can be used as an alarm clock,
whereby the last selected source is switched on
at a set time (one time operation). The clock
time needs to be set first before the timer can
be used.
1 In standby mode, press and hold SLEEP/
TIMER on the remote control for more than
three seconds.
➜ "TIMER SET" is displayed briefly. Then, the
hour digits flash on the display panel.
2 Press VOLUME -/+ (VOL +/- on the remote
control) to set the hours and SLEEP/TIMER
to confirm.
➜ The minute digits flash on the display panel.
3 Press VOLUME -/+ (VOL +/- on the remote
control) to set the minutes and SLEEP/TIMER
to confirm.
➜ "TUN", “DVD” or "USB" flashes.
4 Press VOLUME -/+ (VOL +/- on the remote
control) to select your desired source.
5 Press SLEEP/TIMER to complete the setting.
➜ Display shows .
To deactivate the timer
● Press SLEEP/TIMER again.
➜ disappears.
Sleep timer setting
The sleep timer enables the system to switch off
by itself after a set period of time.
1 Press SLEEP/TIMER on the remote control
repeatedly to select a preset time.
➜ The selections are as follows (time in
minutes):
OFF ™ 15 ™ 30 ™ 45 ™ 60 ™ 75 ™ 90 ™
105 ™ 120 ™ OFF
➜ "SLEEP XX" or "SLEEP OFF" is displayed.
"XX" is the time in minutes.
2 When you reach the desired length of time, stop
pressing SLEEP/TIMER.
➜ Display shows .
To deactivate the sleep timer
● Press SLEEP/TIMER repeatedly until "OFF" is
displayed, or press ECO POWER/
STANDBY-ON y (y on the remote control).
➜
disappears.
pg025-pg037_MCD288E-12-Eng-B 2007.12.21, 17:2233