Filter
Top Products
English
37
Problem
Solution
Left and right sound outputs are
reversed.
The remote control does not function.
The timer is not working
The Clock/Timer setting is erased
Unable to select Progressive Scan.
No sound is output from the HDMI jack.
No sound and picture
Some files on the USB device are not
displayed.
“DEVICE NOT SUPPORTED” scrolls on the
display.
✔ Check the speaker connections and location.
✔ Point the remote control at the remote control
sensor of the unit.
✔ Reduce the distance to the player.
✔ Remove any possible obstacles.
✔ Replace the battery with a new one.
✔ Check that the battery is loaded correctly.
✔ Set the clock correctly.
✔ Power has been interrupted or the power cord
has been disconnected. Reset the clock/timer.
✔ Check that the output of the video signal is
switched to 'Pr/Cr Pb/Cb Y'.
✔ Check the connection between the TV and the
HDMI jack of the DVD player.
✔ See if the TV supports this 480p/576p/720p/
1080i DVD player.
✔ Check your TV system setup correctly.
✔ Check that the RGB/SCART cable is connected
to the correct device (See Connecting TV).
✔ Check if the number of folders exceeds 99 or
the number of titles exceeds 999.
✔ Remove the USB mass storage device or select
another source.
Troubleshooting
pg025-pg037_MCD288E-12-Eng-B 2007.12.21, 17:2237