Filter
Top Products
English
31
Radio Reception
Tuning to radio stations
1 Select TUNER source.
➜ “FM” or “MW” is displayed briefly.
2 Press BAND to select the desired waveband :
FM or MW.
3 Press and hold TUNING S or ¢
(ALBUM-/+ 22 / 33 on the remote) and
then release it.
➜ The display will show "SEARCH" until a radio
station with sufficient signal strength is found.
4 Repeat step 3 if necessary until you find the
desired station.
● To tune to a weak station, press TUNING
S or ¢ (ALBUM-/+ 22 / 33 on the
remote) briefly and repeatedly until you have
found optimal reception.
Programming radio stations
You can store up to 40 radio stations in the
memory (20 for FM and 20 for MW).
Automatic programming
Press PROGRAM (ANGLE/PROG on the
remote) for more than three seconds to
activate programming.
➜ All available stations are programmed.
➜ AUTO is displayed and available stations are
programmed in order of waveband.
Manual programming
1 Tune to your desired station (refer to “Tuning to
radio stations”).
2 Press PROGRAM (ANGLE/PROG on the
remote) to activate programming.
➜ PX flashes on the display, in which X stands
for the programme number.
3 Press ALBUM/PRESET 4/3 to allocate a
number from 1 to 20 for this station.
4 Press PROGRAM (ANGLE/PROG on the
remote) again to confirm the setting.
➜ The frequency of the preset station is shown.
5 Repeat the above four steps to store other
stations.
● You can override a preset station by storing
another frequency in its place.
Note:
– During setting, if no button is pressed within 10
seconds, the system will exit manual programming
automatically.
RDS
CLOCK SETBAND
STANDBY
-
ON
ECO POWER
RECORD
DISPLAY
VOLUME
MCD510 MICRO SYSTEM
INCREDIBLE
SURROUND
PROGRAM
TUNING
ALBUM
/
PRESET
SOURCE
TIMER SET
DBBDSC
iR
pg001-pg040_MCD510_22-Eng 2005.9.5, 16:2931