Filter
Top Products
English
35
Clock/Timer
Clock setting
See page 20.
Timer setting
● The system can be used as an alarm clock,
whereby the CD, TUNER or TAPE is switched on
at a set time (one time operation). The clock
time needs to be set first before the timer can be
used.
1 In standby mode, press and hold TIMER SET3
(TIMER on the remote) for more than two
seconds.
➜ “SELECT SOURCE” scrolls followed by the
last selected source.
2 Press SOURCE to select your desired source
and press TIMER SET3 (TIMER on the
remote) to confirm.
➜ “SET ON TIME” scrolls followed by “ON 0 :
00”.
3 Press TUNING S/T to set the hours
and press TIMER SET to confirm.
4 Press TUNING S/T to set the minutes
and press TIMER SET to complete the setting.
➜ The timer is now set and activated.
Activating and deactivating timer
● In standby or during playback, press TIMER
SET3 (TIMER on the remote) once.
➜ Display shows
if activated, and disappears
if deactivated.
Sleep timer setting
The sleep timer enables the system to switch off
by itself after a set period of time.
1 Press SLEEP on the remote control repeatedly
to select a preset time.
➜ The selections are as follows (time in
minutes):
90 ™ 80 ™ 70 ™ 60 ™ 50 ™ 40 ™ 30 ™
20 ™ 10 ™ OFF
➜ "SLEEP XX" or "OFF" is displayed. "XX" is the
time in minutes.
2 When you reach the desired length of time, stop
pressing the SLEEP button.
To deactivate the sleep timer
● Press SLEEP repeatedly until "OFF" is displayed,
or press ECO POWER/STANDBY-ON y.
DSCIS
/PROG/PROG
RDS
CLOCK SETBAND
STANDBY
-
ON
ECO POWER
RECORD
DISPLAY
VOLUME
MCD510 MICRO SYSTEM
INCREDIBLE
SURROUND
PROGRAM
TUNING
ALBUM
/
PRESET
SOURCE
TIMER SET
DBBDSC
iR
pg001-pg040_MCD510_22-Eng 2005.9.5, 16:2935