Philips MCD802/98 DVD Player User Manual


 
29
The radio tunes to a station with »
strong reception automatically.
3 Repeat step 2 to tune to more stations.
To tune to a weak station, press
/
repeatedly until you fi nd optimal
reception.
Reinstall radio stations
1 Press TUNER.
2 Press and hold PROG for more than 2
seconds.
All previously stored radio stations are »
replaced.
Program radio stations
manually
You can program a maximum of 40 preset
radio stations.
1 Tune to a radio station. (See ‘Tune to a
radio station’ on page 29 )
2 Press PROG to activate program mode.
3 Press / to allocate a number to
this radio station, then press PROG to
confi rm.
The preset number and the frequency »
of the preset station are displayed.
4 Repeat the above steps to program other
stations.
Tip
To overwrite a programmed station, store
another station in its place.
Select a preset radio station
1 In tuner mode, press / to select a
preset number.
8 Listen to the
radio
Tip
For better FM stereo reception, connect the
supplied T-Type antenna.
For optimal reception, fully extend and adjust
the position of the FM antenna.
Position the antenna as far away as possible
from your TV, VCR or other radiation source
to prevent interference.
First time tuning
When you access to radio mode for the fi rst
time, follow the instructions to install the radio
stations.
1 Press TUNER.
’AUTO INSTALL ... PRESS PLAY’ is »
displayed.
2 Press .
All detected radio stations are stored.»
Once complete, it tunes to the fi rst »
preset radio station.
To stop auto tuning, press
.
Note
This unit can store up to a maximum of 40
radio stations.
If auto installation is not activated or less
than 5 radio stations are stored, you will be
prompted to check the FM antenna.
Tune to a radio station
1 Press TUNER to select the tuner source.
2 Press and hold / for more than 2
seconds.
English
EN