Filter
Top Products
7.6 Data Storage
7.6.1 Submenu <Data Storage><<Hard Drive>>
7.6.2 Submenu <Data Storage><<Archive>>
See Archiving, Section 10.
7.7 System
7.7.1 Submenu <System><<Password>>
Available Actions:
• Set Password. Press front panel buttons 1 through 4 to set the password (four to ten characters).
NOTE: This password is the same password used by the Hi-Q Management Utility.
7.7.2 Submenu <System><<Network>>
The Network menu allows access to settings that control the behavior of the recorder with respect to a network.
• Enter the IP, Subnet Mask, and Default Router addresses.
• Enter a Hi-Q recorder name to be used on the network.
* See Appendix D for Hi-Q on-screen character set.
** XXXX is the last 4 digits of the Hi-Q recorder serial number.
21
FIELD VALUES D
EFAULT VALUE
Disk Full Behavior • Overwrite Overwrite
• Stop Recording • Stop Recording is the
default (non-adjustable) if
a disk array is recognized
Disk 1 Status • Good Calculated
• Bad
Disk 2 Status • Good Calculated
• Bad
• Not Installed
Total Capacity Hard disk capacity, in GB Calculated
FIELD VALUES & DEFINITION DEFAULT VALUE
Password Protection • Enabled (requires password Disabled
for menu access)
• Disabled (no password
required for menu access)
FIELD VALUES DEFAULT VALUE
IP Address [0–255 in each block] 10.10.0.0
Subnet Mask [0–255 in each block] 255.255.255.0
Default Router [0–255 in each block] 10.10.0.1
Name [12 Characters]* Hi-Qxxxx**