Filter
Top Products
Specifications, Glossary 51
Specifications
CABINET
Dimensions (w x h x d): 17.13 x 4.53 x 16.38 inches
(435 x 115 x 416 mm)
Weight: Approximately 13.01 lbs (5.9 kg)
POWER SUPPLY
Power supply 120V, 60 Hz
Power consumption Approximately 30W
Standby power consumption <1W
TV STANDARD PAL/50Hz NTSC/60Hz
Number of lines 625 525
Playback Multistandard (PAL/NTSC)
VIDEO PERFORMANCE
CVBS VIDEO OUT 1 Vpp into 75Ω
S-VIDEO OUT Y: 1 Vpp into 75Ω; C: 0.3 Vpp into 75Ω
Y Pr/Cr Pb/Cb Y: 1 Vpp into 75Ω;
Pr/Cr and Pb/Cb: 0.7 Vpp into 75Ω
AUDIO PERFORMANCE (TYPICAL)
DA Converter 24 bit
Signal to Noise (1kHz) 100 dB
Dynamic range (1kHz) 98 dB
Crosstalk (1kHz) 95 dB
Total Harmonic Distortion (1kHz) 91 dB
MPEG MP3 MPEG Audio L3
DVD fs 96 kHz 4 Hz -44 kHz
fs 48 kHz 4 Hz -22 kHz
Video CD/Audio CD fs 44.1 kHz 4 Hz -20 kHz
Super Video CD fs 48 kHz 4 Hz -22 kHz
fs 44.1 kHz 4 Hz -20 kHz
AUDIO FORMAT
Direct Stream Digital/Multichannel/Stereo/MPEG/Compressed Digital
Dolby Digital 16, 20, 24 bits
DTS/PCM fs 44.1, 48, 96 kHz
MP3 96, 112, 128, 256 kbps and
(ISO 9660) variable bit rate fs 32, 44.1, 48kHz
SACD AUDIO PERFORMANCE
DA Converter Direct Stream Digital
Signal to Noise (1kHz) 105 dB
Dynamic range (1kHz) 100 dB
Crosstalk (1kHz) 98dB
Total Harmonic Distortion (1kHz) 91 dB
SACD fs 2.8224 MHz DC 100kHz
Maximum Output Voltage (0dB) 2V rms
Channel unbalance <0.5 dB
Cut-off frequency 50 kHz (Front)
40 kHz (Surround/Center/Subwoofer)
REAR CONNECTIONS
Y Pr/Cr Pb/Cb
(480 lines Interlace/Progressive) Cinch (green/blue/red)
S-Video Out Mini DIN 4-pins
CVBS Video Out Cinch (yellow) (two)
Audio Out Cinch (white/red, left/right)
Digital Audio Out one coaxial, one optical
IEC958 for Audio CD and LPCM
IEC1937 for MPEG1/2
/Dolby Digital/DTS
Front and Surround Cinch (white/red, left/right)
Center Cinch (blue)
Subwoofer (SUB WF) Cinch (black)
LASER
Type Semiconductor laser GaAIAs
Wavelength 650nm (DVD)
780nm (Video CD/Audio CD)
Output power 7mW (DVD)
10mW (Video CD/Audio CD)
Beam divergence 60 degree
Glossary
Analog: Analog sound is available when you use the red and white audio jacks on your equipment. These jacks send audio through
two channels, the left and right.
AUDIO OUT Jacks:
Jacks on the Player that send audio to another system (TV, Stereo, Receiver, etc.).
Bit Rate:
The amount of data used to hold music; measured in kilobits per seconds, or kbps. Or, the speed at which you record.
Generally, the higher the bit rate, or the higher the recording speed, the better the sound quality. Higher bit rates use more Disc
space.
Coaxial jack:
Sends digital audio to a Stereo, allowing you to adjust the volume at the Stereo. The Stereo must have a coaxial in
jack. This connection provides the 5.1 channel surround sound.
Component Video Out Jacks
: Jacks on the back of the Player that send high-quality video to a TV that has Component Video
In jacks.
Digital:
Sound that has been converted into numerical values. Digital sound is available when you use the Coaxial or Optical
Digital Audio Out jacks. These jacks send audio through multiple channels, instead of just two channels as analog does.
Direct Stream Digital (DSD):
Technology used to record SACDs. DSD uses a 1-bit system with a digital sampling frequency
64 times higher than a regular Audio CD, creating a frequency response of over 50 kHz and a 120 dB dynamic range.
Dolby Digital:
A surround sound system that provides 5.1 channel sound.
DTS:
Digital Theater Systems. This is a surround sound system, but it is different from Dolby Digital. The formats were devel-
oped by different companies.
Letterbox:
A TV aspect ratio setting (4:3). Displays the video in full-width, with black bars at the top and bottom of the TV
screen. This format is similar to seeing a movie in a theater.
OPTICAL
Jack: Converts electrical signals into optical signals before sending the audio to the Stereo. Optical audio is not prone
to external electrical influences and has less noise. Keep the protective cap on the jack when it is not in use; this keeps dust out of
the jack.
Pan & Scan:
A TV aspect ratio setting (4:3). Displays the video with full-height picture, with one or both sides of the picture
trimmed. Some movie companies refer to this as “reformatting the picture to fit your TV screen.”
S-Video:
Produces a clearer picture by sending separate signals for the luminance and the color. If you connect the supplied S-
Video cable, you will not need to use the supplied yellow video cable. You can use S-Video only if your TV has an S-Video In jack.
VIDEO OUT Jack:
Jack on the back of the Player that sends video to a TV.
Widescreen:
A TV aspect ratio setting (16:9). Displays the video appropriately when you connect the Player to a widescreen TV.