Philips VR960BPH VCR User Manual


 
If your DBS does not respond to the
code at step 7, the Controller will
not change channels at the DBS
during a timer recording. In this
case, you must select the channel to
be recorded at the DBS before a
timer recording begins. Enter the
DBS output channel (03 or 04) at
step 3 on page 40. Leave the DBS
on for the timer recording. Details
are on page eight.
Helpful Hint
Setting the Controller to Operate a DBS (cont’d) 53
SELECT CODE NUMBER
OF YOUR DBS RECEIVER
40
DID DBS RECEIVER
CHANGE TO CHANNEL 205?
A YES
NO
SELECT: 89 CONFIRM:OK
END: MENU
6
Press the PLAY 8 or STOP 9 button to set the two-digit
code for your DBS (see list below), then press the
OK/STATUS button.
7
Wait for a few seconds.
If the DBS changes to channel 205, go to step 8.
If the DBS doesn’t change to channel 205, press the PLAY 8 or
STOP 9 button to select NO, then press the OK/STATUS
button. Repeat steps 6-7, using a different code for your brand
(if available).
If the DBS does not respond to any of the codes, press the
MENU button to remove the menu. DBS RECEIVER
CONTROL IS OFF will appear on the screen briefly.
8
Press the PLAY 8 or STOP 9 button to select YES, then
press the OK/STATUS button. “DBS RECEIVER CONTROL
IS ON” will appear for five seconds. “AS A RESULT AUTO
CLOCK WILL BE TURNED OFF” may appear on the screen also.
DBS CODES
MAGNAVOX DBS........................................................42, 43
RCA DBS................................................................................40
SONY DBS.............................................................................41
7
Wait for a few seconds.
6-8
VCRTV
VCR/TV
QUICK PROGRAMMING
POWER
STILL/SLOW
SMARTPICTURE
CHVOL
OK/STATUS
TIMER
TURBO REC END
MENU
-
+
CBL / DBS
1 2 3
4 5 6
7 8 9
START STOP DATE
DBS
DAILY
PLAY
REW FF
STOP
WEEKLY
/OTR
RECREC
-
+
-
+
SPEED
0
CLEAR
.............
.............
........
........
SEARCH
MUTE
TIMER
AUDIO/ SKIP
SEARCH
EJECT
ALT
-
-