Filter
Top Products
2322
To Clear all Learned Commands under a mode
Clearing learned commands is helpful if, for example, you
replace your CD player with another brand or model. If
you had learned a feature from your old CD player’s
original remote on to this remote (such as RANDOM
PLAY), that feature would no longer work for your new
CD player. Should you wish to remove or clear one or
more “learned” commands, follow the steps below:
1. Press and hold the SETUP button until CODE SETUP is
displayed (takes about 3 seconds), then release the
SETUP button.
2. Press the down navigation button until LEARN SETUP
is displayed. Press and release OK. MODE LEARN is
displayed.
3. Press the down navigation button until MODE CLEAR
is displayed. Press and release OK.
4. MODE KEY? is displayed. Press and release the desired
Mode button (TV, VCR, DVD, etc.).
5. CONFIRM CLEAR is displayed. Press and release OK.
6. PLEASE WAIT is briefly displayed and the remote exits
Setup Mode and returns to normal operation.
Master Clear - To Clear all Learned
Commands under all modes (recommended on
first time Learning)
1. Press and hold the SETUP button until CODE SETUP is
displayed (takes about 3 seconds), then release the
SETUP button.
2. Press the down navigation button until LEARN SETUP
is displayed. Press and release OK. MODE LEARN is
displayed.
3. Press the down navigation button until ALL LEARN
CLEAR is displayed. Press and release OK.
4. CONFIRM CLEAR is displayed. Press and release OK.
5. PLEASE WAIT is briefly displayed and the remote exits
Setup Mode and returns to normal operation.
Clearing Commands
1. Press and hold the SETUP button until CODE SETUP is
displayed (takes about 3 seconds), then release the SETUP
button.
2. Press the down navigation button until LEARN SETUP is
displayed. Press and release OK.
3. MODE LEARN is displayed. Press and release OK.
4. MODE KEY? is displayed. Press and release the desired
Mode button (TV, VCR, DVD, etc.).
5. LEARN KEY? is displayed. Press and release the remote
key to be taught with original remote code.
6. LEARNING is displayed. Press and hold the original
remote key until the SUCCESS or LEARN ERROR is
displayed (see Tips on Learning, page 20) followed by
the LEARN MORE? (this process can take up to 2 or 3
seconds to complete). Release the original remote button.
7. LEARN MORE? is still displayed. To learn more buttons,
press and release OK and repeat from step 5. To exit at
this point, press and release the QUIT.
8. PLEASE WAIT is displayed briefly and the remote exits
Setup Mode and returns to normal operation.
Learning Commands
Line up your remotes (that you’re learning from) in front of the
Learning remote, on a hard surface approx. 1 inch apart.