Filter
Top Products
ADAPTING REMOTE CONTROL ENGLISH
44
44
1 Press the
MMEENNUU
button on the remote
control.The on-screen menu appears
AAddaappttiinngg rreemmoottee ccoonnttrrooll
If you are using two video recorders which both react to the same
remote control codes, you can use this function to change remote
control and video recorder to other codes.
2 On the remote control press the buttons
SSEELLEECCTT
and
22 ssiimmuullttaanneeoouussllyy
, to set the video
recorder to VCR 2 (or
SSEELLEECCTT
and
11
, to set
it to VCR 1)
3 Confirm with
OOKK
. The screen will show
RESPONDS TO VCR 2 or RESPONDS TO
VCR 1.The on-screen menu disappears The
adjustment of the remote control is complete
MAIN MENU
CLOCK
AUTO INSTALL
MANUAL SEARCH
TV CHANNEL ALLOC.
RECORD SPEED
AUTO STANDBY
TV SYSTEM
SPECIAL SETTINGS
EXITPMENU OK
WWhhaatt aarree rreemmoottee ccoonnttrrooll ccooddeess??
Each time the button on your remote control is
pressed,an invisible infra-red signal is sent to the video
recorder. Each button has been allocated a specific
code, which ensures, that the video recorder will carry
out the corresponding function. If two video recorders
respond to the same codes, the remote control signal
emitted will be recognised and performed by both.
Therefore the possibility exists, to allocate different
remote control commands (with other codes) to this
video recorder.This means that the uninterrupted use
of both video recorders is possible once more.
PP
AARRDDOONN
??
TTIIPP
WWhhaatt mmuusstt II sseett??
If two video recorders respond to the same codes,
they are either both set to VCR 1 or VCR 2.Please
change the setting of only one video recorder! The
factory setting of the video recorder is VCR 1.
PPRROOBBLLEEMM
88 MMyy oonn--ssccrreeeenn mmeennuu ddooeess nnoott ddiissaappppeeaarr
44
The video recorder does not recognise the change
of remote control codes. Repeat steps 2 and 3
88 AAfftteerr tthhee bbuuttttoonnss aarree pprreesssseedd
VCR 1
oorr
VCR 2
aappppeeaarrss iinn tthhee ddiissppllaayy ooff tthhee vviiddeeoo rreeccoorrddeerr
44
Repeat step 2 to reset the remote control to the
displayed settings