Filter
Top Products
Controls and displays03
20
En
Using the remote control
Keep in mind the following when using the
remote control:
• Make sure that there are no obstacles
between the remote and the remote sensor
on the unit.
• The remote has a range of about 7 m (23 ft).
• Remote operation may become unreliable
if strong sunlight or fluorescent light is
shining on the unit’s remote sensor.
• Remote controllers for different devices
can interfere with each other. Avoid using
remotes for other equipment located close
to this unit.
• Replace the batteries when you notice a
fall off in the operating range of the remote.
Setting up the remote to
control your TV
You can use the supplied remote to control
your TV. To be able to use this feature you first
have to program the remote with a maker code
from the table below.
1 Press and hold down the CLEAR button,
then enter the maker code for your TV.
See the table below for the list of maker codes.
If there is more than one code given for your
make, input the first one in the list.
• If the maker’s name of your TV doesn’t
appear in the table below, you will not be
able to use this remote to control your TV.
2 Press TV to check that the remote
works with your TV.
If the remote is set up correctly, the TV should
switch on/off. If it doesn’t and there is another
code given for your maker, repeat step 1 with a
new code.
Using the TV remote control buttons
The table below shows how to use this remote
control with your TV.
Button What it does
TV Press to switch the TV on/off
(standby)
INPUT SELECT Press to change the TV’s video
input
VOLUME +/– Use to adjust the TV volume
CHANNEL +/– Use to change TV channels
Maker Code
Aiwa 38
Funai 36
GE 11, 28
General 34
Goldstar 10, 23
Grandiente 30
Hitachi 06, 24, 25, 32
Magnavox 12, 29
Mitsubishi 09
NEC 37
Panasonic 08, 22, 41
Philips 07
Pioneer 00, 35, 40, 44
RCA 01, 15, 16, 17, 18
Sanyo 14, 21
Sharp 02, 19, 27
Sony 04
Toshiba 05, 26, 31, 43
JVC 13, 33, 42
Zenith 03, 20
03_controls_displays.fm 20ページ ２００６年６月２３日 金曜日 午後２時２２分