Filter
Top Products
24
En
Playing DVDs, Video CDs and
CDs – DVD/Video CD/CD
Before you can start to enjoy the digital audio and video
on DVDs, be sure that you have made the necessary
settings in the Setup screen menus outlined in the
previous section to correspond to your home system.
Having made these settings, you are now ready to start
using the player to enjoy DVDs, Video CDs, and CDs.
Illustrations of the player in this section show the
DV-525K. Differences in the different models are as
follows.
• The MIC input jack, VOLUME and ECHO controls are
not present on the DV-525.
• The STANDBY/ON switch is not present on the
DV-525 (except for Taiwan model).
1 Press STANDBY/ON on the front panel (
on the remote control). (DV-525K and DV-525
(Taiwan model) only)
1
Press POWER on the front panel. (DV-525
only (except for Taiwan model))
2 Press OPEN/CLOSE (0 on the front panel).
The disc tray comes out.
3 Load a disc.
Load a disc with the label side facing up, using the
disc tray guide to align the disc.
4 Press 3 (play) (3 on the front panel).
• The disc tray closes, and playback begins.
• Depending on the disc, a menu may be
displayed. If a menu is displayed, proceed to
step 5.
5 Select the item you want to view.
• When a DVD is loaded:
Select the item with the cursor buttons (2/3/5/
∞) or the number buttons, then press ENTER.
• When a Video CD is loaded:
Use the number buttons to select the item.
Notes
• Noise is output if you make digital audio connections to a
receiver or amplifier that does not have a built-in decoder.
Check that the digital audio output format selected in the
Audio 1 menu corresponds to the audio components you have
made connections to (page 21).
• The TV screen size is factory set to present the wide screen
format (16:9 aspect ratio). If you have a standard TV screen
(4:3 aspect ratio), this setting can be changed to match your TV
screen size in the Video menu (page 22).
Getting Started
Using Your DVD
Player
0
4
¢
1
¡
7
8
3
5
5
5
5
4
¢
1
8
7
eE
¡
3
2
5
4
5
1
STANDBY/ON
0
4
¢
1
¡
7
8
3
23
1(1) 4
When an operation is prohibited
There are times when you are using the player and attempt to
perform an operation, but for some reason it cannot be
performed. When this occurs, one of the two following icons
appear on the screen.
The operation is prohibited by the player.
The operation is prohibited by the programming on
the disc.
Procedures in this section use the DV-525K and the
DV-525 (Taiwan model) as models. Differences in
procedures between models are clearly marked by white
numbered steps.