Filter
Top Products
41
PRV-LX10
En
English
Recording
Editing the Edit List
The contents that can be recorded on the edit list
with this recorder are as follows:
The contents set with the APP section = [Auto
Capture] = [IN/OUT Point] and [Chapter Point]
commands are added to the edit list by pressing the
Add to EDL button.
Also, the APP section = [Auto Capture] = [EDL
Command] command can be used to add disc
finalize and initialize commands and wait functions to
the edit list as well. The wait function can be used to
place EDL recording in REC pause mode when
necessary, for example, to change the recording
source’s VTR tape during EDL recording.
Note:
When recording to DVD, if the unit is left in the
recording standby mode for 1 hour or more, the unit
will automatically switch to STOP mode to prevent
damage to the system.
APP section = [Auto Capture] = [EDL Command]
= [Command]
When selecting the APP section = [Auto Capture]
= [EDL] command, the items entered on the edit list
cannot be edited (changing order, deleting).
In particular, the contents set with the APP section
= [Auto Capture] = [Chapter Point] command
must be recorded as the next step after setting and
recording the IN/OUT points where you wish to
insert chapter marks.
If chapter points are set and recorded after earlier
setting and recording multiple IN/OUT points, the
chapter points will be added as an additional record
at the end of the edit list, and thus must be changed
to their proper order.
APP section = [Auto Capture] = [EDL]
Note:
When recording the edit list, the final IN/OUT point
setting must be as follows: APP section = [Auto
Capture] = [IN/OUT Point] = [Record As]
command must be set to “Title(Stop)”.
APP section = [Auto Capture] = [EDL] items editing
(example 1)
APP section = [Auto Capture] = [EDL] items editing
(example 2)
Eject Setting
The operation performed at time of eject can be set
using the [Eject Setting] command on the SETUP
section’s [Operation] = [Control Setting] menu.
When set to “Eject”, the disc will be ejected
immediately without finalization even during
recording.
When set to “Finalize&Eject”, when the eject
command is received from an external controller at
the remote control (RS-422A/IEEE1394), the disc will
be finalized, and then ejected.
Also, when using the front panel controls to eject a
disc, if the drive for the EJECT button pressed is
the same as the drive selected with the DRIVE
SELECT button, a dialog box will appear asking
whether you wish to finalize the disc.