Filter
Top Products
The Initial Setup menu
13
99
En
Additional information about the TV system
settings
About the input line system
This recorder is compatible with PAL, SECAM, 3.58 NTSC
and PAL-60 TV systems. The Input Line System and Input
Colour System settings determine how the recorder
treats incoming video signals from an external input or
the built-in TV tuner.
Please note the following points when changing the
input line system:
• When the current input is a built-in tuner channel
preset, changing the input line system will usually
also affect the input line system of the
AV2/AUTO
START REC (INPUT 1/DECODER)
input. However if
the
AV2/L1 In
setting is set to
Decoder
, then the L2
input is affected instead.
• If, when the Input Line System setting is changed, the
screen goes blank (due to incompatibility with your
TV), you can switch back by pressing and holding the
front panel
button then pressing
OPEN/CLOSE
(front panel) while the recorder is stopped.
• When you switch the Input Line System setting the
Copy List is erased. If you switch the setting using the
button and
OPEN/CLOSE
buttons as described
above, there is no confirmation, so please use with
care.
• You can’t mix recordings of different TV line systems
on the same disc.
• When you change this setting, the
Input Colour
System
setting also changes (see below).
About NTSC on PAL TV
Depending on the Input Line System setting and the
NTSC on PAL TV setting, the signal format output when
the recorder is stopped varies as shown in the table
below.
About the input colour system
The available options of the Input Colour System setting
depend on the Input Line System setting. The table below
shows the different options available.
Additional information about component
video output
If you switch the Component Video Out setting to
Progressive
when using a TV that is not compatible
with progressive-scan video, you will not be able to see
anything displayed on your TV. If this happens, press and
hold the
button on the front panel, then press
. This will set the recorder’s video output back to
Interlace.
Input Line System
NTSC on PAL
TV
Output when
stopped
625 System Off PAL
On PAL
525 System Off NTSC
On PAL–60
Input Line System Built-in tuner External input
625 System Auto Auto
PAL PAL
SECAM SECAM
525 System
n/a
Auto
3.58 NTSC
PAL–60
Compatibility of this unit with progressive-scan TVs
Consumers should note that not all high-definition television sets
are fully compatible with this product and may cause artifacts to
be displayed in the picture. In case of 525 progressive scan
picture problems, it is recommended that the user switch the
connection to the ‘standard definition’ output (
Interlace
). If there
are questions regarding our TV set compatibility with this model,
please contact our customer service center.
This recorder is compatible with the following Pioneer displays
and monitors
Plasma display
•PDP-503HDE, PDP-433HDE, PDP-434HDE, PDP-504HDE, PDP-
435XDE, PDP-435HDE, PDP-435FDE, PDP-505XDE, PDP-
505HDE, PDP-615EX
DVR-433H_UK.book 99 ページ ２００５年３月１日 火曜日 午後５時６分