Filter
Top Products
Recording
05
44
En
• Cancel Once
– A regular timer program
is set to skip.
• Can’t Rec
– Not possible to record.
•
Title Over
– Can’t record because there
is already the maximum number of titles
on the disc (HDD: 999; DVD: 99).
• Recording
– The program is currently
recording.
• Standby
– The recorder is in timer
recording standby.
•
nothing displayed
– Another timer
recording or copying is in progress.
6 To exit the timer recording screen,
press HOME MENU.
Tip
• To enter a title name for the timer
recording in advance, select
Set Title
Name
and follow the on-screen display.
Note
• If you set a DVD timer recording but
there is no recordable DVD disc loaded,
or the disc loaded doesn’t have enough
free space for the complete recording,
Recovery
is shown. In this case (unless
you load a suitable disc before the
recording actually starts), the recorder
will use the HDD for recording. (The
message
Can’t Rec
will appear if there
are already 999 titles on the HDD or if
there is not enough free space on the
HDD for recording.)
• For a DVD timer recording, if
Optimized
Rec
(see
Optimized Rec
on page 114) is
set to
On
, the recorder will adjust the
recording quality to try and fit the
recording on the disc. If the recording
will not fit onto the disc even on
MN1
(
MN4
for DVD+R/+RW) recording
quality then the Recovery Recording
feature will automatically make the
recording to the HDD instead.
• If there is very little free space left on the
HDD, an Auto Replace Recording may
not complete successfully.
• If the HDD is being used for playback or
high-speed copying when an Auto
Replace Recording is due to start, the
new timer recording will not replace the
old one. However, the next time the timer
recording starts, both of the older two
programs will be erased.
Editing a timer program
You can change any of the settings in a timer
program before the recording is due to start.
1 Press HOME MENU, select Timer
Recording, then Timer Recording.
2 Highlight the timer program you
want to change
..
..
3 Press
then select ‘Modify’ from the
command menu panel.
Alternatively, press
ENTER
.
The Timer Program Set screen appears from
which you can edit the settings.
4 Edit the timer recording settings as
necessary.
5 Select ‘Store Program’ to finish.
Confirm the settings you made from the
following screen.
Deleting a timer program
You can delete timer programs you no longer
need.
1 Press HOME MENU, select Timer
Recording, then Timer Recording.
DVR640H_KU_EN.book 44 ページ ２００６年３月７日 火曜日 午後３時１８分