Filter
Top Products
ADJUSTING AUDIO AND VIDEO SETTINGS
27
En
DTS Out
This player is capable of outputting DTS digital audio for
DVDs recorded in DTS. When this player is connected to
an AV component that has a built-in DTS decoder, select
[DTS]. If your system is not equipped to decode DTS,
select [Off]. Refer to the operating instructions supplied
with your audio components if you are unsure about
compatibility with DTS.
96 kHz PCM Out
This player is capable of outputting digital signals with a
sampling frequency of 96 kHz. If you have made
connections to a component capable of processing this
signal rate, select [96 kHz] for the signal to be output as
is. As some components are incapable of processing
digital signal input with sampling rates of 96 kHz,
selecting [96 kHz 3 48 kHz] compresses the signal to a
standard signal with a sampling rate of
48 kHz.
Settings: Off*
DTS
*Factory setting
Note
If you have made digital audio connections to component(s)
not equipped to decode the DTS digital bitstream, be sure to
select [Off]. If a DTS signal is output without decoding, the
output is digital noise that could potentially cause damage to
your speakers.
Settings: 96 kHz 3 48 kHz*
96 kHz
*Factory setting
Note
On DVDs that contain copy protection, the 96 kHz signal may
only be output from the analog audio jacks.
—
—
—
—
V2Video1
General
A2
Language
Exit
Move
Audio DRC
Dolby Digital Out
DTS Out
96kHz PCM Out
MPEG Out
Audio1
Off
Dolby Digital
Off
DTS
MPEG 3 PCM
Change DTS output mode
SETUP
—
—
—
—
SETUP
V2Video1
General
A2
Language
Exit
Move
Audio DRC
Dolby Digital Out
DTS Out
96kHz PCM Out
MPEG Out
Audio1
Off
Dolby Digital
Off
96kHz 3 48kHz
96kHz
Change 96kHz output mode
Digital Out
Expert
– DVD/Super VCD/VCD/CD
Depending on your preferences and the type of
connections made, you may opt not to have the digital
audio signal output at all. When this setting is set to
[Off] there is no signal output from the digital audio
output jacks.
Make changes to the [Digital Out] setting in the Setup
screen Audio 1 menu in the [Expert] menu mode (page 25).
MPEG Out
This player is capable of outputting the MPEG digital
bitstream. When the player is connected to an AV
component that has a built-in MPEG decoder, select the
[MPEG] setting. Otherwise, select [MPEG 3 PCM] to
convert the digital signal to the PCM signal, the digital
signal output from a CD.
Settings: MPEG
MPEG 3 PCM*
*Factory setting
Settings: On* (Digital bitstream is output)
Off (Digital bitstream is not output)
*Factory setting
—
—
—
—
—
SETUP
V2Video1
General
A2
Language
Exit
Move
Audio DRC
Dolby Digital Out
DTS Out
96kHz PCM Out
MPEG Out
Audio1
Off
Dolby Digital
Off
MPEG
MPEG 3 PCM
Change MPEG audio output mode
—
—
—
—
—
—
V2Video1
General
A2
Language
Exit
Move
Audio DRC
Dolby Digital Out
DTS Out
96kHz PCM Out
MPEG Out
Digital Out
Audio1
Off
Dolby Digital
Off
96kHz 3 48kHz
MPEG 3 PCM
On
Off
SETUP