56
En
Additional
Information
Disc Care
How to hold discs
When loading or removing
discs, try not to touch their
playing surfaces.
Cleaning
Fingerprints or other dirt on the disc may affect sound
and picture quality.
To clean your discs, use a soft clean cloth to wipe them.
If necessary, moisten a soft cloth with diluted neutral
detergent to remove heavy dirt or fingerprints.
Discs must not be cleaned with record cleaning sprays,
or static prevention sprays, etc. Also do not use volatile
liquids such as benzine, or thinner, etc.
Never play cracked or warped discs
The disc revolves in the player at
high speed when it is played. Never
play a cracked, scratched or warped
disc. This may damage the player or
cause it to malfunction.
Never use discs with special shapes
CD’s with special shapes (heart-
shaped CDs, octagonal CDs, etc.)
cannot be played on this set.
Attempting to do so may damage the
set. Do not use such CDs.
Gently wipe from the
inside toward the outer
edge.
Do not wipe in a circular
direction (Concentric
scratches in the disc groove
tend to cause noise).
After using discs, store them upright
After playing a disc, always remove it from the player
and return it to its jacket. Then store it standing upright
away from heat and humidity.
• Store discs carefully. If you store discs at an angle, or
stacked on top of each other, discs may become
warped even when in their jackets.
• Do not leave discs in locations such as the seat of a
car, which may become excessively hot.
• Do not fix labels or stickers to discs. The disc may
become unplayable as a result.
• Do not load more than one disc into the player.
CAUTION WHEN USING THE DISC
All rights reserved.
Unauthorized public performance, broadcasting or
copying is a violation of applicable laws.
For Proper and Long Use of
This Unit
Do not move the unit during playback
During playback, the disc rotates at high speed. Do NOT
lift or move the unit during playback. Doing so may
damage the disc.
When moving the unit
When changing places of installation or packing the unit
for moving, be sure to remove the disc and return the
disc table to its original position in the player. Then,
press STANDBY/ON and switch the power to
standby. Check that the “--OFF--” indication on the
display goes off, then disconnect the power cord.
Moving this unit with the disc loaded may result in
damage to this unit.
Installation
• Select a stable place to the side of a TV set or stereo
system to be connected to the unit.
• When using the unit with a stereo system, install the
speakers a little bit away from the TV.
• Do NOT install the unit on top of a TV or color monitor.
Install the unit away from equipment that may be
affected by magnetism, such as a cassette deck.
• Do NOT place objects on top of the unit.
Avoid installing in a place that is:
• Exposed to direct sunlight
• Exposed to humidity or where ventilation is poor
• Extremely hot or cold
• Exposed to vibration
• Exposed to dust
• Exposed to oily smoke, steam or heat (for example, a
kitchen)
Do not block vents
Do NOT use the player on top of a long-fibered carpet,
bed or sofa, and do not cover it with a cloth, etc. This
will prevent heat radiation and could result in damage.