Filter
Top Products
32
En
Adjusting the picture quality settings
To create your own setting (1)
1 Use the cursor button (3) to select [Start]
then press ENTER.
DISPLAY
ENTER
Memory
Move
Select
Off 1 2 3
Check
Video Memory Select
Video Setup
2 Use the cursor button (∞) to select [Video
Setup] then press ENTER.
3 Use the cursor buttons (2/3) to select the
setting to [On] or [Off].
6 Repeat steps 4 and 5 to make adjustments
to other settings.
If you would like to save the settings in the player’s
memory, be sure to select either [1], [2], or [3] in
the [Memory] setting to establish which memory
location to save the new settings in. Please note
that if you select a location where settings have
already been saved, the old settings will be
replaced by the new ones.
7 When you are finished making
adjustments, press ENTER to establish the
new settings.
To create your own setting (2)
1 Use the cursor button (3) to select [Start]
then press ENTER.
Memory
Fine Focus
Contrast
Sharpness
Chroma Level
Hue
On
Off
soft fine
min max
min max
green red
Off 1 2 3
2 Use the cursor button (∞) to select [Video
Setup] and press ENTER.
3 Press DISPLAY.
DISPLAY
ENTER
Fine Focus On Off
Move
Select
Check
Video Memory Select
Video Setup
4 Use the cursor buttons (5/∞) to select the
setting to adjust.
You can adjust any or all of the following picture
quality factors:
Fine Focus
Switch on to reveal greater detail (higher resolution)
in the picture.
Contrast
Adjusts the contrast of the elements in the picture.
Sharpness
Adjusts the sharpness of the mid-frequency (less
detailed) elements in the picture. (This setting is
only effective when [Fine Focus] is [On].)
Chroma Level
Adjusts how saturated colours appear.
Hue
Adjusts the overall colour balance between red and
green. (This is only effective when the player is
connected using the VIDEO OUT or S-VIDEO
OUT jacks.)
5 Use the cursor buttons (2/3) to adjust the
settings.
Adjust these while a disc is playing to see the effect
of changes immediately.
4 Use the cursor buttons (5/∞) to select the
setting and use the cursor buttons (2/3)
to adjust the settings.
Adjust these while a disc is playing to see the effect
of changes immediately.
5 To memorize the setting, select [Memory1,
2, 3], then press ENTER.
The previous setting will be erased.
Video Memory Select
Video Setup