Filter
Top Products
Connecting up
02
16
En
Connecting using the
component video output
You can use the component video output
instead of the standard video out jack to
connect this player to your TV (or other equip-
ment). This should give you the best quality
picture from the three types of video output
available.
• Use a component video cable (not
supplied) to connect the COMPONENT
VIDEO OUT jacks to a component video
input on your TV, monitor or AV receiver.
• To set up the player for use with a progres-
sive scan TV, see
Component Out
on
page 56
.
• Only NTSC video is output when set to
progressive scan.
DV-667A Taiwanese model
only: Connecting using the
D1/D2 video output
If your TV is equipped with a D type video
input, you can use a D video cord to connect
this player to your TV.
• Only NTSC video is output when set to
progressive scan.
• This player is compatible with D1, D2, D3
and D4 input jacks, however, when
connected to a D1 jack, only interlace
video is output.
• If you connect the S-video jack and the D
video connector, and one of the
connected components is not S1/S2
compatible, the automatic aspect ratio
switching will not work with any of the
connected components.
S
L
R
L
R
P
R
PB
Y
COAXIAL
OPTICAL
FRONT SURROND
SUB
WOOFER
CENTER
DIGITAL
AUDIO OUT
COMPONENT VIDEO OUT
AUDIO OUT(2CH)
AUDIO OUT
(5.1CH)
VIDEO OUT
TV
COMPONENT
VIDEO IN
S
COAXIAL
OPTICAL
CONTROL
IN OUT
D1/D2
VIDEO OUT
DIGITAL
AUDIO OUT
TV
D1/D2
VIDEO INPUT
DV-667A Taiwanese model
DV563.book 16 ページ ２００３年４月２５日 金曜日 午後８時１１分