Filter
Top Products
<ARB1527>
83
OTHERS
USING THE DIGITAL TUNER (sold separately) TO WATCH DTV
2
Select the channel of the DTV program
you wish to record. (Refer to steps 2 to 5
on pages 78 to 81.)
1
Connect the rear panel MONITOR/DTV
OUTPUT jack and the VCR input jack.
SUB CH
SELECT
FREEZE
SPLIT
MENU
SET/
ENTER
∞
5
DTV
EDIT/
SOURCE
INFO
INPUT
RECEIVER
4
¢
MENU
VOL
INPUT
VOL
AUDIO
1 2 3 4
DTV
GUIDE
8
LEARN
CH
RETURN
POWER
POWER
POWER
SEARCH
ON/OFF
VCR REC
CH
TV
VOL
TV/
DTV
CBL
/SAT
DVD
/LD
VCR
1 32
4 65
7 98
0
MUTING
POWER
POWER
CH
ENTER
FAVORITE CH
17 3¡
2 3
MODE
DISPLAY
ANT
DTV/SAT
DTV/DVD TOP
DTV/(SAT)
TV/SAT/DVD
SCREEN
TV
3
Press MENU and select SET UP by using
the 5 or ∞ button and then pressing SET/
ENTER. (Refer to page 26.)
4
Select DTV OUT in the same way.
EXIT
USE: END: MENU
SET UP
CHANNEL SET UP
CONVERGENC
DPO:OFF
SYSTEM IN/
E
OUT
PROGRAM BLOCK
CHANGE PASSWORD
DTV OUT:OFF
SET/
ENTER
5
Set DTV OUT to ON.
ON OFF
EXIT
USE: END: MENU
SET UP
CHANNEL SET UP
CONVERGENC
DPO:
SYSTEM IN/
E
OUT
PROGRAM BLOCK
CHANGE PASSWORD
DTV OUT:
OFF
SET/
ENTER
6
After setting, press MENU to turn the
menu off.
7
Signals will then be output from the
MONITOR/DTV OUTPUT jack. Turn on
the power to your VCR and then begin
recording.
2 3
∞
5
SET/
ENTER
2 3
SET/
ENTER
5
∞
NOTES:
•
The DTV OUT settings screen is displayed when
an SH-D09 digital tuner is connected.
•
Turning DTV OUT ON will make it impossible to
change DTV channels. DTV OUT must be turned
OFF in order to change channels.
•
When the DTV OUT is turned to ON, the MONITOR/
DTV OUTPUT jack becomes the DTV specialized
output jack and an NTSC signal is output. Also note
that the monitor picture quality will be equivalent
to the picture quality described on NTSC.
•
Turning the power to the Projection Monitor off will
cause signals to no longer be output from the
MONITOR/DTV OUTPUT jack, and you should
accordingly be careful not to turn off the power
while recording.
•
It the power to the Projection Monitor is turned OFF
then ON when DTV OUT is ON, DTV OUT turns OFF.
•
When DTV OUT is turned to ON, the channel
change, multi-screen (SPLIT, FREEZE, SEARCH
screen) and screen position (V. POSITION) functions
cannot be used.