Filter
Top Products
8
Operations on the Receiver and Cable Connections (Continued)
2 Perform the “Full Auto MCACC” operation on the receiver. (See page 10 of the
receiver’s Operating Instructions.)
The setting here is not required if the “Full Auto MCACC” operation has already been performed before
connecting the RS-232C cable. Proceed to step 3.
3 From the receiver’s “Manual MCACC” menu, select “EQ Professional”, then select
“Reverb Measurement” to measure the room’s reverb characteristics.
(See page 50 of the receiver’s Operating Instructions.)
If you want to measure the room’s reverb characteristics, select “EQ OFF”, then select “START”.
If you want to measure the room’s reverb characteristics after equalization, first perform the “Full Auto
MCACC” operation, then select “EQ ON”, then “START”. (See page 23
.)
Measure the room’s reverb characteristics after equalization with the microphone at the same position as
when the “Full Auto MCACC” operation was performed. The measurements are performed with the EQ
values stored in the MCACC memory selected on the receiver, so before measuring the reverb
characteristics, select the MCACC memory to be measured after equalization.
4 Select “Output PC” from “MCACC Data Check”. (See page 72 of the receiver’s
Operation Instructions.)
The message “Start the MCACC application on your PC” appears and the receiver enters transmission
standby mode. It is ready to send data to your PC.
This completes the preparations for sending the measurement data to your PC.
(To send the data, proceed to the next section Application Operations.)
Note
MCACC : M1.MEMORY 1
1c5a.Reverb Measurement
A/V RECEIVER
Exit Cancel
START
Reverb Measure with
: EQ OFF
MCACC : M1.MEMORY 1
1c5a.Reverb Measurement
A/V RECEIVER
Exit Cancel
START
Reverb Measure with
: EQ ON
Start the MCACC application on your PC.
2g.Output PC
Exit Cancel
A/V RECEIVER
a. Speaker Setting
b. Channel Level
c. Speaker Distance
2.MCACC Data Check
d. Standing Wave
e. Acoustic Cal EQ
f. Group Delay
g. Output PC
A/V RECEIVER
Exit Return