Filter
Top Products
INSTALLATION & OPERATIONAL SSHLV SERIES MANUAL
L20-407 rev. 1 (3/14) 19
4
5. COMPUTER CONTROLLER OPERATION
31L2
5
4
68
7
0
9
R
5.1. TO TURN THE APPLIANCE ON:
If power is applied to the appliance, the displays will show [OFF]. Press the [I/O] key.
Displays will show one of the normal displays: [HEATING]; [MELTING]
[SOLID]/[LIQUID]; or [READY]. Some messages may show in both left and right
displays. Wait for the appliance to heat up to the [READY] condition before cooking.
5.2. TO TURN THE APPLIANCE OFF:
Press the [I/O] key. Display will momentarily show the software version number and then
[OFF][OFF]. Use the Left [I/O] key for left side and Right [I/O] key for the right of dual vat
control 60126802. Either key may be used on the single vat controller.
5.3. TO START A COOK:
When displays are showing [READY] the appliance has reached set temperature and is
ready to cook. Press the desired product key, and place product into the vat. The
indicator above the product key will flash to indicate the cook timer is running. In the
example above, product 4 is cooking with 2 minutes and 28 seconds remaining. The right
side display has no running cook timers, and shows [READY].
Multiple cooks may run together. While cooks are running, the displays will always show the cook with
the least time remaining. Longer running cooks will flash their indicators at a slower rate. Cook time
remaining on these keys may be checked by momentarily pressing the product key.
5.4. TO CANCEL A COOK:
Press and hold the product key to cancel a running cook. If no other cooks are pending, controller
displays will return to [READY].
5.5. TO VIEW ACTUAL AND SET TEMPERATURES:
To view the actual vat temperature, press the thermometer key. The display will show
[ACT nnnF] or [ACT nnnC], where nnn is the current vat temperature. After a few
moments, the display will return to [READY], [MELT ], or [HEATING] when no cooks are
running, or, [CKn mm:ss] for any cooks still running.
To view the set temperature, press the thermometer key twice. The display will
show [SET nnnF] or [SET nnnC], where nnn is the current set temperature. After a
few moments, the display will return to [READY], [MELT ], or [HEATING] , or,
[CKn mm:ss] for a cook still running.