Filter
Top Products
AMC-101 Installation & Operation Manual Chapter 2 - Installation & Setup
Site Requirements 2-3
Installation of
Two Units
Rack adapter components for installing two units include two long side rails
(one for each unit) which slide one into the other fastening the two units
together, and two short side brackets which hold the two units in the
19'' rack (see Figure 2-4).
Figure 2-4 Installation of Two Units (a)
To install two units follow these instructions:
1. Fasten one lon
g
side rail to each unit (ri
g
ht side to one unit, left side to
the other unit) usin
g
the four screws and flat washers su
pp
lied. The side
rails must be attached in o
pp
osin
g
fashion, the narrow flan
g
e of the first
rail opposite the wide flange of the second rail.
2. Attach one short bracket o
pp
osite the side rail on each unit usin
g
the
four screws and flat washers supplied.
3. Slide the side rail of one unit into the side rail of the other unit, fastenin
g
the two units together (see Figure 2-5).
4. Secure the su
pp
lied
p
lastic ca
p
s to the ends of the rails, to
p
revent the
units moving and to protect the rail ends.
5. Place the assembled units in the rack and fasten the brackets to the side
rails of the rack, by means of the four screws situated on each side
(not included in the kit).