Filter
Top Products
10
Setup
11
Setup
Connecting an Antenna
Indoor Antenna
Plug one end of a 75-ohm coaxial cable with an F connector (not supplied) to the TUNER
jack on back of the TV, and its other end to the antenna (not supplied).
Outdoor Antenna
For best reception, use a high-quality outdoor antenna (not supplied).
Plug one end of a 75-ohm coaxial cable with an F connector (
not supplied)
to the TUNER
jack on the back of the TV, and the other end to the antenna’s wall outlet. If your outdoor
antenna uses a 300-ohm coaxial cable, plug it into the TUNER jack using a 300-to-75-ohm
transformer.
If you have separate UHF and VHF antennas, connect the separate antenna cables to a
VHF/UHF combiner, then connect the combiner’s output to the TUNER jack on the TV.
wWarning: When you install an outdoor antenna, use extreme caution. If the antenna starts
to fall, let it go! It could contact overhead power lines. If the antenna touches the power line,
contact with the antenna, mast, cable, or guy wires could cause electrocution and death. Call
the power company to remove the antenna. DO NOT attempt to remove it yourself!
Connecting an HDMI Device
Use a standard high speed HDMI cable (not supplied) to connect to the HDMI port. The
HDMI connection supports HD video signal up to 720p.
Connecting a Component Video Device
1. Connect the device’s component outputs (Y/Pb/Pr) to the COMPONENT jacks on the
back of the TV. Match the colors on the connection cables with the colors on the jacks. For
component cables and jacks, Green = Y, blue = Pb, and red = Pr.
2.
Use an audio cable (not supplied) to connect a device’s audio output jacks to the AV-IN
audio jacks on the back of the TV. Red jacks are for right audio, and white jacks are for
left audio.
nNote: Component cables do not provide audio. Use component cables for video and
composite L/R audio cables for audio.
Connecting an S-Video Device
1. Use a S-video cable (not supplied) to connect a device’s S-Video output to the TV’s
S-VIDEO jack.
2. Use an audio cable (not supplied) to connect a device’s audio output jacks to the AV-IN
audio jacks on the back of the TV. Red jacks are for right audio, and white jacks are for
left audio.
Connecting a Composite Video Device
1. Use a video cable (not supplied) to connect each device’s video output to the TV’s
COMPOSITE video jack.
2. Use an audio cable (not supplied) to connect a device’s audio output jacks to the AV-IN
audio jacks on the back of the TV. Red jacks are for right audio, and white jacks are for
left audio.
nNotes: Both S-Video and COMPOSITE share the same set of audio jacks on the back of
the TV.
VHF/UHF Combiner
VHF Antenna
UHF Antenna
S-Video Cable
Audio Cables