Filter
Top Products
12
Setup
13
Setup
Connecting a PC
1. Your TV automatically adjusts the screen resolution and saves it when receiving a VGA
signal from a PC. If the receiving signal is not the standard mode signal, refer to the
table to set your PC’s resolution.
Resolution Vertical Frequency Horizontal Frequency
640 x 480 (VGA) 60 Hz – / –
72 Hz – / –
75 Hz – / –
720 x 400 70 Hz – / +
800 x 600 60 Hz 48.363 KHz
1024 x 768 (XGA) 60 Hz 63.974 KHz
1280 x 800 (recommended) 60 Hz 49.6 KHz
2. Use a VGA cable (not supplied) to connect the PC RGB port on the back of the TV to the
VGA port on your PC.
3. Use a PC audio cable (not supplied) to connect the PC-AUDIO jack on the back of the
TV to the audio out jack on your PC.
Connecting to a Home Theater
Connect audio and video through your A/V receiver/amplifier
1. Connect audio and video cables from your DVD player or other device to your A/V
receiver/amplifier, then connect the receiver/amplifier to the TV.
2. Refer to the instructions from your A/V receiver/amplifier or speaker system to make
speaker connections.
n Note: For best results, use the highest quality of audio/video cables that your devices
will accept. Use the same type of audio and video cables to go from the device to the
receiver/amplifier and from the receiver/amplifier to the TV.
Optimal Speaker Layout
A/V Receiver/
Amplifier
TV
DVD Player or
Other Device
VGA Cable
PC Audio Cable
Video Out
Video In
Y Pb Pr
AM
LOOP
FM UNBAL
75
Ω
ANTENNA
FRONT
R
L
CENTER
SURROUND
S
K
E
R
S
R
L
SUB WOOFER
S-VIDEO
Audio Out
Audio In
Component Video
Out
In
Audio
Coaxial
Digital
Audio
Video
Y
PR
PB
L
R
S-VideoCoaxialHDMI