Filter
Top Products
Connections & Setup
Chapter 1 9
Place All Available Channels Into Memory
1. To go to the Setup menu, with the master remote (CRK17TD1), press
MENU then select Setup. In this menu you'll be able to set your
Signal Type. Next go to Auto Channel Search, the TV will search for
all channels viewable through your antenna or cable TV system.
2. Select which channel list you’d like to find channels for (List A is the
default).
3. Press the down arrow button to select Start. Press the OK button to
start searching. The TV searches for active channels and places them
in the channel list.
Note: Video Input Channels (VID, SVID, etc.) must be added to the
active channel list separately before they can be accessed. Refer
to the Setup menu section at the end of this chapter for more
information on the Channel menu and List & Labels.
Set the Time
The current time options might not be available to the basic user,
depending on how they've been set by the master user. (The Time
Configuration menu isn't available in the basic menu).
To set the time, from the Main menu select Time
then Time Config. If the
current time has not been set, use the arrow and number buttons on the
remote control to make changes.
1. From the Main menu, highlight Time and press OK.
2. Time Config. is highlighted. Press the right arrow to enter the menu.
3. Time is highlighted. To set the time press the right and left arrow
button to add or subtract minutes. Use the number buttons to set the
hour. The OK button changes am and pm.
The ClonePRO™
If several TVs need to be programmed with the same menu settings, an
optional ClonePRO remote can be used to copy all of the menu settings
from one TV into other TVs to reduce installation time. Information can
be both downloaded to and uploaded from the ClonePRO using the
DSCI port on the TV’s back panel or using the IR sensor. A ClonePRO
can be obtained from your RCA commercial distributor. Chapter 2 has
information about this remote, see page 20. If you want to set other
menu options before using the ClonePRO, continue on in this chapter.
You can use the ClonePRO at any time.
Go Back
Time Config. ...
Sleep Timer 00:00
Wa
ke-Up Timer ...
Schedule ...
TIME
Go Back
Time 08:25AM
Set Time Access Disabled...
Time Offset None....
TIME CONFIG
AUTO CHANNEL SEARCH
Go Back
Channel List List A...
Start Running...
Channel 012
Press OK to start the
Auto channel search
1644105Ae.indb 9 7/18/05 2:27:18 PM