Filter
Top Products
40 Chapter 5
Chapter 5: Commercial Interface Menus
Commercial Interface
OnCommercial Interface
Clone Management
Channel
OSD
Source
Volume
Pillow Speaker
Power Management
Key Management
Reset Commercial Interface
MENU
Back
ENTER
OK Select
FF GG
GG
GG
GG
GG
GG
GG
GG
GG
GG
Power Management
Commercial Interface
Off
Off
Off
On
Auto Power On
Auto Power Off
Power Always On
No Signal Power Off
MENU
BackSelect
FF GG
FF GG
FF GG
FF GG
- Auto Power On : This function sets the power state when AC power is applied to the TV.
+ Off : TV will go to stanby mode
+ On : TV will turn on
+ Last : TV will resume the state it was in before AC power was removed.
- Auto Power Off : This function assigns the amount of time an inactive TV will remain on. It can be used by
your facility to save energy.
- Power Always On : TV can not be turned off.
- No Signal Power Off: If there is no signal on the TV for 5 minutes or more, this function turns off the TV
automatically.
Commercial Interface
OnCommercial Interface
Clone Management
Channel
OSD
Source
Volume
Pillow Speaker
Power Management
Key Management
Reset Commercial Interface
MENU
Back
ENTER
OK Select
FF GG
GG
GG
GG
GG
GG
GG
GG
GG
GG
Pillow Speaker
Commercial Interface
Off
Off
20
0
100
CH Hold
Power Off in Channel List
Pillow Initial Volume
Pillow Min Volume
Pillow Max Volume
MENU
BackSelect
FF GG
FF GG
FF GG
FF GG
FF GG
- CH Hold : If this function is on then TV will turn off when CH key is held for 4 seconds on an analog pillow
speaker.
- Power Off in Channel List : If this function is on then TV will turn off when CH+ key is pressed on last
channel.
- Pillow Initial Volume : TV is configured to Initial Volume when TV is in pillow speaker mode.
- Pillow Min Volume : TV limit minimum volume when TV is in pillow speaker mode.
- Pillow Max Volume : TV limit maximum volume when TV is in pillow speaker mode.