Filter
Top Products
37Chapter 5
Chapter 5: Commercial Interface Menus
Commercial Interface
OnCommercial Interface
Clone Management
Channel
OSD
Source
Volume
Pillow Speaker
Power Management
Key Management
Reset Commercial Interface
MENU
BackSelect
FF GG
GG
GG
GG
GG
GG
GG
GG
GG
GG
-You must set “Commercial Interface” to “On” to activate the below items.
Commercial Interface
OnCommercial Interface
Clone Management
Channel
OSD
Source
Volume
Pillow Speaker
Power Management
Key Management
Reset Commercial Interface
MENU
Back
ENTER
OK Select
FF GG
GG
GG
GG
GG
GG
GG
GG
GG
GG
Commercial Interface
On
Virtual
TV
Antenna
Off
Off
Direct Tuning Access
ATSC Tune Mode
Power On Source
Tuner Mode
Power On Major Channel
Power On Minor Channel
Channel Hold
Merge Channel
MENU
BackSelect
FF GG
FF GG
FF GG
FF GG
2
0
FF GG
FF GG
Channel
These TVs include a full commercial interface that allows your facility to customize the performence to your
specific needs. These settings are only accessible to the installer with the use of the Master
Remote(KM38R01).Contact your RCA Commercial Distribution to obtain a master remote.
You can access this menu by pressing MENU -> 9 -> 6 -> 3 -> 2 using the Master Remote.
Commercial Interface
OnCommercial Interface
Clone Management
Channel
OSD
Source
Volume
Pillow Speaker
Power Management
Key Management
Reset Commercial Interface
MENU
Back
ENTER
OK Select
FF GG
GG
GG
GG
GG
GG
GG
GG
GG
GG
Commercial Interface
On
60Sec
Off
Channel Banner
OSD Timer
Clear V-Chip
Power On CC
MENU
BackSelect
FF GG
FF GG
FF GG
- Channel Banner : If this function is off then channel banner will not appear when channel is changed.
- OSD Timer : Use this setting to configure the menu OSD time out.
- Clear V-Chip : This function can be used to Clear V-Chip password and settings.
- Power On CC : This function sets the default Closed Caption mode when the TV is turned on.
OSD
- Direct Tuning Access : If this function is on, you can tune to channels even if the channels are not in the
channel list using the numeric keys. If this function is off, only channels in the channel list can be tuned.
-ATSC Tune Mode : This function sets the channel frequency type for Digital Channels to physical or virtual.
If the facility has a head end signal distribution system, set this to “physical”.
- Power On Source : Use this setting to configure the signal source of the TV when it is turned on.
-Tuner Mode : Use this setting to configure the Tuner Type of the TV when it is turned on.
Note: “Power On Source” should be set to “TV” to use this setting.
- Power On Major/Minor Channel : Use this setting to configure the initial channel of the TV when it is
turned on.
Note: “Power On Source” should be set to “TV” to use this setting.
To tune to an analog channel, set minor channel to 0.
- Channel Hold : If this function is on then you cannot change channels.
- Merge Channel : Use this setting to merge scanned channel lists In Antenna of Tuner mode and scanned
channel lists In Cable of Tuner mode.