Filter
Top Products
18
Setting up
TV
ON OFF
AUX
DVD
SOUND
GO BACK
C
H
+
C
H
-
V
O
L
V
O
L
SKIPMUTE
INFO
MENU
OK
CLEAR
GUIDE
VCR1
VCR2
SAT•CABLE
TV
button
Step 1: Plug In The Monitor
Plug the end of the power cord into an appropriate wall outlet. Be sure
to insert the plug completely.
Step 2: Place batteries in remote
• Remove the battery compartment cover from the back of the
remote by pushing down on and sliding off the cover.
• Insert fresh batteries. Make sure that the polarities (+ and -) are
aligned correctly.
• Replace the cover.
Step 3: Turn on the Monitor
Press TV on the remote, or press POWER on the monitor’s front panel.
Pressing the TV button not only turns on the monitor, but puts the
remote into TV mode, so that the buttons on the remote will control
monitor functions.
The Point and Select Navigation Method
You can “get around” in the menu system by using just a few buttons
on the remote control. We call this the “Point and Select” method of
navigation, and it has two steps.
1. Point to a menu item using the arrows on the remote.
To point up or down, press the up or down arrows. To point left or
right, press the left or right arrows.
2. Select a menu item by pressing MENU or OK.
Selecting an item tells the monitor’s menu system to go ahead and
make the change or go to a place you have indicated.
Step 4: Set Up the GUIDE PIUS+ Gold System
The first time you turn on the monitor, you will see the GUIDE Plus+
Gold screen. You need to set up the GUIDE Plus+ Gold system so it can
display your local program listing and control your cable box and VCR.
To complete the GUIDE Plus+ Gold setup, the GUIDE Plus+ Gold G-LINK
cable wand must be properly aligned with the remote sensor on your
cable box and VCR if you have them. Refer to the Making Connections
section for additional information.