Filter
Top Products
Using the Remote
23
CLEAR Removes any menu or display from the screen and returns you
to normal viewing.
(0-9) Number Buttons Enters channel numbers and time settings
directly though the remote control. To enter a two-digit channel, press
the two digits. To enter a three-digit channel, press and hold the “1”
button until “1” and two dashes (– –) appear, then add the second two.
Example: to tune to channel 123, press and hold 1 until
“1– –” appears, release the 1 button and then press 2, and 3.
WHO•INPUT In TV mode, press to toggle through the available input
sources (VID1, VID2, VID3, FRONT, last channel, VGA1, VGA2, component
input). In SAT mode, press to select available channel lists (RCA, GE, and
PROSCAN products only).
ANTENNA Functions as TV/VCR button in VCR mode and TV/receiver
button in satellite mode.
REVERSE, PLAY, FORWARD, REC•VCR+, STOP, PAUSE If
programmed, provides transport control for some remote-controllable
VCRs, DVD players, laserdisc players, tape decks, and CD players. Pressing
REC•VCR+ when using the GUIDE Plus+ System sets the VCR to record a
program.
PIP Brings up the small picture-in-picture window. Press again to
remove the PIP window. (See “PIP Feature” later in this manual for more
information about using PIP.)
SWAP Swaps the main picture with the PIP window.
CH CTRL Selects the picture window, (that is, the main or PIP window)
to be changed by the CH ^ (channel up) or CH v (channel down) buttons.
RESET Resets picture quality controls to the Bright Lighting Picture
Control Preset. Point and select to choose a different Picture Control
Preset. Also used to reset the settings in a menu, such as the Parental
Controls menu.
Using the WHO•INPUT button
Use the WHO•INPUT button to scroll through the available input
channels and view components you have connected to the monitor.
1. Press TV to place the remote in TV mode. Make sure that the
component you want to view is turned ON.
2. Press WHO•INPUT to tune to an available input channel.
3. Continue to press the WHO•INPUT button to scroll through the
input channels.
Programming the Remote
The universal remote can be programmed to control most brands of
remote controllable VCRs, satellite receivers and cable boxes. The remote
is already programmed to control most RCA, GE, and PROSCAN TVs,
VCRs, DVD players, laserdisc players and satellite receivers.
Modes of Operation
Because this universal remote can control
several different components (DVD
player, VCR, Cable Box, etc.) it uses
operational modes triggered by the
component buttons. For example if you
want the remote to control the TV, you
would press the TV button to put the
remote into TV mode before you could
control the TV.