RCA P46728 CRT Television User Manual


 
Date and
ADJ. (Adjust)
Button
DA TE/TIME
Button
Cell Compartment
Cell
Holder
Display in Viewfinder
AM 12:00:00
\1/
1 . I .1993
MDei__- _ l
Hours and
AM or PM
Minutes
--Seconds
Install the Lithium Cell for Time and Date Display
l. Pull out the cell holder.
2. Insert the cell with the "+" terminal up.
3. Replace the cell holder.
Note: The lithium cell should last about one
year. When it expires, the date display shows
"'88:88". Reset the date and time after
replacing the cell.
Cautions: Lithium cell battery. Must be disposed of properly.
Never handle punctured or leaking cells. May cause hui'_ or pe_s0n_l
injury. _:_ _!,:!:,__._.%:_:: _:_ _. _ii_ _,_ _:._ _,,
Keep out of the hafids of Children. Can cause death or mju_"it
swallowed, If swallowed, consult a physician immediately for : ::_'_:.!_
emergency treatment. ::./_.,._:._.i.:i:_:.__,:,_:..:: ._,___,_:_._:::__ ::i _:_:::::_i:.:_,:,:_ii_
The lithium cell used in this d_vice _a_t :expl_ r_:ulting:]n a :fi_ _r
:chemical burn if mistreated. Do not re_hal:ge,disassemble, heat above
212°F (100° C), or incineratel
Never use metallic tweezers to hold the cell, aiid neversfiort ci_i_':_the
+ and - sides of the battery..::: :,:.::i _::_:_i
Set and Record the Time and Date ...............
Record the Time and Date
Whenever time and date or date appear in the
viewfinder, it will be recorded on the tape.
Press the DATE,'TIME button to display and
remove the time and date.
Press ........... To Display in Viewfinder :i
DATE/TIME : and Record on the Tape .....
Button
.............. i
Press Once Date Only
Press Again Date and Time
Press Again Neither Date nor Time
Set the Time and Date
1. Install the lithium cell as described above.
2. Attach a power supply to the camcorder. Press
and hold the small button on the POWER switch
while you slide it to CAM. Place the ON/POWER
SAVE lever in ON.
3. Use a straightened paper clip or pen to press and
hold the ADJ. (adjust) button for about one second.
The reset date (1.1. 1993) and time (AM
12:00:00) will appear in the viewfinder.
4. The month will flash. Repeatedly press DATE/
TIME button until the correct month appears.
22
5. Then, press the ADJ. button. The flashing cursor
will move to the next part of the display.
6. Repeat steps 4 and 5 until you have entered the
correct month, day, year, hour including AM or
PM, and minute.
.
After setting the minutes, press the ADJ. button to
start the seconds. The seconds counter will start
with "00".
To correct the date or time after the clock has been
started, repeat steps 3-7.