RCA RC5220P DVD Player User Manual


 
87
Reference
Using Direct Entry
1. Turn on the TV to be programmed.
2. Look up the brand and code number(s) for the TV on the code list
in this section.
3. Point the DVD Player’s remote at the TV.
4. Press and hold the TV button on the remote you want to program.
5. Enter the code from the Remote Control code list (pp. 88).
6. Release the TV button, and then press ON•OFF to see if the TV
responds to the command. If it doesn’t, try pressing the TV button
and then ON•OFF again.
7. If you get no response, repeat these steps using the next code
listed for your brand, until the TV responds to the remote
commands.
Note:
This remote may not be compatible with all brands and models of televisions
This Is Important!
You must continue pressing the TV button
while you enter the code.
Let’s say you have a Zenith TV. To program the
remote to operate the TV you would:
Press and hold the TV button while you enter
the first code listed for Zenith in the TV Codes
column.
Release the TV button. Press ON•OFF to see if
the TV responds. If it doesn’t, follow the same
steps, but enter the second code instead of the
first.