41
STEREO
STEREO SAP
SAP
TV SETUP
V-CHIP SET
ON/OFF TIMER
PICTURE
AUDIO
SURROUND
STABLE SOUND
SAP
〈
▲/▼/ENTER/MENU
〉
ON OFF
ON OFF
ON OFF
Stereo recording and playback / Second Audio Program (SAP)
When a MTS STEREO broadcast is
received, the word STEREO will ap-
pear on the screen and the program can
be viewed or recorded in stereo.
The Hi-Fi STEREO recording procedure
is the same as for normal recordings.
The VHS Hi-Fi audio system permits high
fidelity recording of MTS STEREO TV
broadcasts.
NOTES:
When playing back a tape that is not
recorded in Hi-Fi stereo mode, the
audio will automatically be monaural.
When listening to a VHS Hi-Fi video
tape or MTS broadcast through the
VHF/UHF jack (Audio/Video cord not
connected), the sound will be
monaural.
Stereo recording and
playback
NOTE:
When using a CATV system, stereo TV programs may be transmitted
over a mono cable channel. In this case the word "STEREO" will not
appear and the sound will be in mono.
When viewing an MTS STEREO TV program, or playing a prerecorded
VHS Hi-Fi STEREO video tape, press AUDIO SELECT to select how
the audio will be heard through the speakers. Normally set to the Hi-Fi
STEREO position, this button can be set to the MONO position if the
stereo broadcast or videotape audio is of poor quality. The "R" and "L"
positions allow the audio from the Right or Left Hi-Fi channel to be heard
over both TV speakers. This button has no effect when viewing a MONO
video tape or TV program. Each time when you press the button, OUT-
PUT SELECTION display appears on the screen for several seconds.
Refer to the chart below.
Output selection
OUTPUT
SELECTION
STEREO
L ch
R ch
MONO
SOUND HEARD ON BOTH
SPEAKERS
STEREO
LEFT CHANNEL AUDIO
RIGHT CHANNEL AUDIO
MONO
Your unit is fitted with a SAP broadcast system which enables
you to switch to a second audio program when viewing a
selected channel.
This function applies only when the program is broadcast in
multi-languages through the SAP broadcast system.
Second Audio Program (SAP)
Press TV MENU in the TV/VCR mode. Then press or to
select "TV SETUP", then press ENTER.
1
2
Press or to select “SAP”.
Then press ENTER
to select “ON”.
Then press TV MENU until the
menu screen is cleared.
When the unit is turned on or a channel selection is made, make
certain the letters "SAP" appear on the screen. This means that the
"Second Audio Program" broadcasting is available.
Listening to SAP
OR
•
•