Filter
Top Products
2
RDV-985 DVD Player
WARNING: There are no user serviceable parts in-
side. Refer all servicing to qualified service person-
nel.
WARNING: To reduce the risk of fire or electric shock,
do not expose the unit to moisture or water. Do not
allow foreign objects to get into the enclosure. If the
unit is exposed to moisture, or a foreign object gets
into the enclosure, immediately disconnect the power
cord from the wall. Take the unit to a qualified ser-
vice person for inspection and necessary repairs.
Read all the instructions before connecting or operating the
component. Keep this manual so you can refer to these safety
instructions.
Heed all warnings and safety information in these instruc-
tions and on the product itself. Follow all operating instruc-
tions.
Clean the enclosure only with a dry cloth or a vacuum cleaner.
You must allow adequate unobstructed clearance around the
unit. Do not place the unit on a bed, sofa, rug, or similar sur-
face that could block the ventilation slots. If the component
is placed in a bookcase or cabinet, there must be ventilation
of the cabinet to allow proper cooling.
Keep the component away from radiators, heat registers, stoves,
or any other appliance that produces heat.
The unit must be connected to a power supply only of the type
and voltage specified on the rear panel of the unit.
Connect the component to the power outlet only with the sup-
plied power supply cable or an exact equivalent. Do not modify
the supplied cable in any way. Do not attempt to defeat ground-
ing and/or polarization provisions. Do not use extension cords.
Do not route the power cord where it will be crushed, pinched,
bent at severe angles, exposed to heat, or damaged in any
way. Pay particular attention to the power cord at the plug
and where it exits the back of the unit.
The power cord should be unplugged from the wall outlet if
the unit is to be left unused for a long period of time.
Immediately stop using the component and have it inspected
and/or serviced by a qualified service agency if:
• The power supply cord or plug has been damaged.
• Objects have fallen or liquid has been spilled into the unit.
• The unit has been exposed to rain.
• The unit shows signs of improper operation
• The unit has been dropped or damaged in any way
Place the unit on a fixed, level surface strong enough to sup-
port its weight. Do not place it on a moveable cart that could
tip over.
For U.S.A.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential in-
stallation.
This equipment gene rates, uses and can radiate radio fre-
quency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to ra-
dio communications. However, there is no guarantee that in-
terference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or tele-
vision reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to cor-
rect the interference by one or more of the following mea-
sures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
help.
IMPORTANT FOR LASER PRODUCTS
1. CLASS 1 LASER PRODUCT
2. DANGER: Visible laser radiation when open and inter-
lock failed or bypassed. Avoid direct exposure to beam.
3. CAUTION: Do not open the top cover. There are no user
serviceable parts inside the player; leave all servicing to
qualified service personnel.
REPRODUCTION OF LABELS
1. Classification label, placed on rear enclo-
sure.
2. Warning label, placed inside unit.
WARNING!
To reduce the risk of electrical shock, fires, etc.:
1. Do not remove screws, covers or cabinet.
2. Do not expose the unit to rain or moisture.
3. Do not touch the power cord or plug with wet hands.
Caution – POWER Button Operation
The POWER buttons on the front panel and the remote con-
trol switches the unit between “On” and “Standby” modes.
They do not disconnect the power mains. The power cord must
be unplugged from the wall to shut power off completely.
Caution: Proper Ventilation
To avoid the risk of electric shock and fire and to protect from
damage, observe the following minimum clearance require-
ments:
Front No obstructions, open access
Sides 1
1
/4” / 30mm minimum clearance
Top 2” / 50mm minimum clearance
Back 6” / 150mm minimum clearance
Bottom No obstructions, place on a level surface