Filter
Top Products
7-2
Service Mode
Identification
Highlight ‘Identification’ with the control disc and press ENTER.
The ‘Identification’ screen gives information concerning :
- Projector address. To change the address of your projector, contact a
qualified service technician.
- Software version.
- Configuration.
Possible installations :
* Front-ceiling
* Front-table
* Rear-ceiling
* Rear-table
- Baud rate PC : transfer speed for communication with an IBM PC (or
compatible) or MAC. The baud rate of the projector must be the same
as the baud rate of the connected computer. When there is a differ-
ence, contact a qualified service technician to make the appropriate
changes.
- Text ON/OFF
Indicates in operational mode if the bar scale and number indicator
will be displayed and if warnings and failures will be displayed.
ON : displayed
OFF : not displayed
The status can be changed by pressing the ‘TEXT’ key once on the
RCU.
- Serial no. : indicates the fabrication number of the projector. This
number can be useful when calling for technical assistance.
ENTER will start the selected item.
EXIT returns to the Service mode menu.
PROJECTOR SET-UP
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE: operating
Select with
then <ENTER>
<EXIT> to return.
or
IDENTIFICATION
RUNCO
DTV - 992
Proj. address : 001
Soft. Version : 6.00
Config. :Ceiling
Front
Baudrate PC : 9600
Text : ON
Serial No. : 103589552
Copy a block
The copy a block function copies the settings of a selected block into
the active block.
Highlight copy a block with the control disc and press ENTER.
To copy the settings of a closed block to the block you are working on
(active block), use the control disc to select a block.
All existing settings will be overwritten with the new settings.
Press ENTER to copy the selected block. A confirmation screen will be
displayed.
If you are certain you wish to copy the contents of the selected block into
the active block, press ENTER.
EXIT cancels the copy procedure and returns without copying the block.
ENTER displays a confirmation screen.
EXIT returns to the Service Mode main menu.
MEMORY MANAGEMENT
DELETE A BLOCK
DELETE ALL BLOCKS
ALL SETTINGS TO MIDPOS
R & B CONVERGENCE MID
GR CONVERGENCE MID
Select with
then <ENTER>
<EXIT> to return.
or
COPY A BLOCK
ENTER will select the highlighted item.
EXIT returns to the Path Selection main menu.
ADJUST returns to the Operational mode.
COPY MODE
Nr. Src Fh Fv inp conf
1 1 15.6 50 video FC
2 3 31.2 60 RGB3S RT
3 - 15.6 50 intern FC
4 2 31.5 50 RGB3S FC
5 - 33.7 60 intern FC
6
7
8
Active block nr.
1
Select with
then <ENTER>
<EXIT> to return.
or
COPY BLOCK
All settings
in current block
will be overwritten !
Select with
then <ENTER>
<EXIT> to return.
or