Filter
Top Products
8-1
MESSAGES, WARNINGS, AND FAILURES 8
SOURCE 01
Fh= 15.6 kHz
Fv= 050 Hz
When selecting a new source,
information about this source will be
displayed on the screen. Source
number, horizontal and vertical
frequencies of the displayed source.
WARNING:
source not available
The input is a valid input but
the source is not connected
to the input terminals or the
input source is switched off.
SOURCE 01
Fh= 15.6 kHz
Fv= 050 Hz
Announcement of the selected
source.
WARNING:
invalid
key entry
When a wrong key is
pressed on the RCU.
enter password
xxxx
Message to enter your password.
Password contains 4 digits.
WARNING:
invalid
code entry
Message when the entered
pass word is wrong.
text on
These messages will be displayed
on the screen when pushing the
<TEXT>
key.
Text ON : the
`bar scale indication'
will be enabled during the change
of an analog control in the
`operational mode'+
all warnings
and failures will be displayed.
WARNING:
end of adjust range
End of adjustment range.
text off
Text OFF : the
`barnacle indication'
will be disabled during the change
of an analog control in the
`operational mode's
all warnings
and failures will not be displayed.
WARNING:
input no longer
available
Message will be displayed
when the input source is no
longer available. The
following message then
appears:
`check input signal
or select new source'.
PROJECTOR
ADDRESS:
003
Indication of the projector ad dress
when activating the
`AD DRESS'
button on the RCU with a pencil or
other small object.
check input signal
or select
new source
This message will be
displayed after the message
`input no longer available'.
It
asks to check the
connections between the
source and the projector or
to check if the source is
switched on.