Filter
Top Products
Installation
28 Runco LS-1 Installation/Operation Manual
PRE
L
IMINAR
Y
Adjusting the Projection
Angle
If the screen is significantly higher or lower than the projector, you can also tilt the
projector at a slight angle. In a ceiling installation, you do this by adjusting the ceiling
mount.
For a floor installation, turn the adjustable feet at the bottom of the projector to adjust the
projection angle.
The projector can be rotated (side-to-side) up to 360 degrees and mounted without it
affecting performance. However, to ensure optimal performance of the lamp, limit the
front-to-back tilt of the projector to ±20 degrees; see
Figure 3-7.
Figure 3-7. Mounting Angle Ranges (Side-to-Side and Front-to-Back)
If you do this, you may need to vertically shift the image to compensate. For detailed
instructions, refer to
Lens Adjustments on page 38.
➤
± 360º
± 20º