Filter
Top Products
Installation
40 Runco LS-1 Installation/Operation Manual
PRE
L
IMINAR
Y
3.11
Installing and
Adjusting the
Anamorphic Lens
If you are installing an LS-1 with an anamorphic lens, proceed as follows to install and
adjust that lens.
Fixed Anamorphic Lens The fixed anamorphic lens mount kit consists of everything shown in Figure 3-16. Some
components shipped with your projector may differ slightly from what is shown in these
instructions.
Figure 3-16. Anamorphic Lens Mounting Assembly - Exploded View
It is extremely important that the primary lens is properly
adjusted before you install the anamorphic lens. Ensure that
the image from the primary lens is perfectly centered on the
screen.
Note
➤
3 Height/Pitch Adjustment
Screw, 4-40 x 1/4" (4x)
4 Swell
Latch
Assembly
(2x)
1 Anamorphic Lens
2 Washer (4x)
6 Anamorphic Lens
Base Plate
5 Anamorphic Lens
Mounting Bracket